Attachment to the decree: BMDW-92.211/0089-I/12/2018 Anton Paar GmbH_17025C
Scope of Accreditation of Calibration Laboratory (EN ISO/IEC 17025:2005)
Anton Paar GmbH / (ID number: 0630)
Valid from 25/09/2018
Fluid and Gas Quantities, Density and Viscosity Density of Liquids
No. Measured Quantity //
Measurement Range OC
2)
Measurement
Uncertainty1)
Measurement Conditions Calibrated Device Remarks
1 Density of Liquids //
650 to 1550 kg/m³
� 0.02 kg/m³ Calibration by direct
comparison with reference
liquid
Density meters based on
the oscillating U-tube
principle
2 Density of Liquids //
998 kg/m³
� 0.1 kg/m³ Comparison measurement with
a calibrated density meter
Reference standard The comparison
measurement is
carried out with a
calibrated density
meter. The reference
standard is intended
for internal use only.
1) Best measurement capability according to EA-4/02 for calibrations under laboratory conditions.
These are expanded measurement uncertainties with a coverage probability of 95 % and, unless otherwise indicated, with a coverage factor k = 2.
Measurement uncertainties without units are relative values in relation to the measurement value unless otherwise mentioned.
2) If marked, on-site calibration is also possible (The measurement uncertainty might be larger as for calibrations done under laboratory conditions).
This page is not a binding translation. In case of any ambiguities, the German original text must be used.
Attachment to the decree: BMDW-92.211/0089-I/12/2018 Anton Paar GmbH_17025C
Scope of Accreditation of Calibration Laboratory (EN ISO/IEC 17025:2005)
Anton Paar GmbH / (ID number: 0630)
Valid from 25/09/2018
Temperature, Humidity and Thermophysical Quantities Temperature
No. Measured Quantity //
Measurement Range OC
2)
Measurement
Uncertainty1)
Measurement Conditions Calibrated Device Remarks
3 Temperature
(fixed point cell) //
0.01 °C
� 1.5 mK Triple point of water (TPW) Standard Platinum
Resistance Thermometer
Fixed point
calibration according
to ITS-90
4 Temperature
(fixed point cell) //
29.7646 °C
� 2 mK Gallium melting point Standard Platinum
Resistance Thermometer
Fixed point
calibration according
to ITS-90
5 Temperature //
0 °C – 200 °C
� 10 mK Calibration bath /
Metrology well
Platinum Resistance
Thermometer
6 Temperature //
0.01 °C – 29.6747 °C
� 2 mK TPW, Gallium Fixed Point Standard Platinum
Resistance Thermometer
Fixed point
calibration with
deviation function
according to ITS-90
7 Temperature //
15 °C – 50 °C
� 15 mK Temperature
measurement chain
Comparison
calibration with
reference
thermometer
This page is not a binding translation. In case of any ambiguities, the German original text must be used.
