Steel Skid 35 lb 12” I-Beams with
cross members and outriggers
2 x 12 Floor Joists-16” O.C. Flooring is nailed & screwed and are doubled every
48”. A “ladder” header is installed @ front and rear of floor for installation support to steel skid. Floor Decking is 1 1/8” Thick!
R-38 Floor Insulation with 1-layer of foil bubble insulation
Entire Floor is covered with 30 GA Galvanized Steel
Installation of 16”x16” vinyl floor tiles. Floor is sanded and cleaned and floor tiles are glued and rolled and installed over
entire floor.
Pre-engineered roof trusses installed 16” O.C . Trusses are glued and
foamed to ceiling panels
Insulated duct for Heating/Air
Conditioning of unit
Installed in roof cavity and supported with
strapping.
Exterior walls: 2” x 6” @ 16” O.C. Interior walls: 2” x 4” @ 16” O.C.
All walls are strapped to floor and roof area and screwed per code.
Installation of roof area to unit. Roof will be screwed and strapped to unit
Exterior walls are insulated with R-21Fiberglass insulation
Exterior Sheathing for unit is 7/16” OSB with 1-layer of foil bubble
insulation.
Roof area is insulated with R-49 fiberglass insulation and is covered with 7/16” structural grade OSB
Unit is built with Low-E insulated windows with clear
glass. Exterior walls are covered with 26 GA “R-panel”
colored steel
Roof area is covered with roof paper and exterior
metal trim pieces are installed prior to install of
steel roof
Installation of 30 GA galvanized steel over roof
with a gutter flange installed to length of unit.
Electrical: Unit is powered to a 200 amp service panel. Each unit will include a H.V.A.C: 2.5 /4.0 ton
exterior mount unit.
Exterior Doors: 30”x68” steel door with steel framing and flange.
Exterior Incandescent light with cover is installed next to door.
Baths: 1 pc. Fiberglass shower(s) are included. Vanity area—cultured marble top
with single lever faucet /bar light with medicine cabinet and towel bar and tissue
holders
Digital Thermostat
Recessed wall mounted heater
Ceiling Vent for Heat/AC
Standard 2-Bulb ceiling light fixture
Strip light with receptacle. Mounted above area of bunk
Drain line(s), water-inlet valve accessible from exterior. Unit will have (2) exterior weather resistant receptacles
Weather-Proof Exterior box for communications to be brought into the bunk
unit.
Kitchen: Wood framed cabinet doors with base and overhead cabinets. Appliance: Upgraded range, microwave over range and refrigerator.
Cabinets will also include shipping clips for transportation closure.
Skid unit—Office area. Desk areas included with countertops, drawers, and overhead cabinets.
Office area also includes all electrical receptacles and phone jacks at desk
area(s)
Safety: All Skid units will include “EXIT” signs @ exterior doors and a fire
extinguisher mounted under kitchen sink area