Download - Tilted Horn Antenna Simulation 66
DescriptionIn this filter design, tuning is achieved by modifying the configuration of the screws located in the top face of the waveguide without changing the entire SolidWorks assembly. Here, tuning focuses on the depth of penetration of the screws, i.e., keeping their diameters and positions constant, in order to control the frequency response of the filter.They have low SWR broad bandwidth and simple construction and adjustment
FIGURE 1: RF TUNABLE FILTER CONFIGURATIONNA
Simulation
A number of scattering parameters simula-tions will run according to each configura-tion. The frequency range for each simula-tion is between 6 and 7 GHz. We can use the fast sweep plan with a center frequency or the discrete frequencies plan (in which we run every frequency simulation individually) for more precision.
Boundary Conditions
The filter is a Perfect Electric Conductor. We can apply this boundary condition to the fac-es of the model taking advantage of the skin depth effect.
This hint can inspire the use different config-urations to vary dimensions within the Solid-works model and finally gather all results in single plots for comparison. The model is made of waveguide sections having dimen-sions of 17.4x34.79 mm and iris sections hav-ing dimensions of 17.4x23.22 mm. There are 13 tuning screws identified by S1-S13 in this filter design.
The mesh has to take into consideration the varying parts of the model which are the tuning screws. The mesh size has to be conformal to the size of the screw and its penetration.
Results
At the user defined center-fre-quency, we can view the electric and magnetic field in different set-tings: i.e. iso and section clipping, animating the field through vary-ing its omega-T phase, changing the colors of the chart to show intensity... Here is an animation showing the propagation of the wave from input to output at 6.6 GHz (the center frequency of the fast sweep frequency plan)
Figure 2: 3D Radiawape propagation in the filter
Mesh
This hint can inspire the use different config-urations to vary dimensions within the Solid-works model and finally gather all results in single plots for comparison. The model is made of waveguide sections having dimen-sions of 17.4x34.79 mm and iris sections hav-ing dimensions of 17.4x23.22 mm. There are 13 tuning screws identified by S1-S13 in this filter design.
By using the section clipping feature, we can view the electric field distribution around one screw. Here is a capture of en electric field spotted within one of the tuning screws. The colors are intuitively interpreted: close to red is stronger, close to blue is weaker.
HFWORKS
APPLICATIONS
Figure 3: Return Loss of the filter within various configurations
As mentioned earlier, the results can be gathered and illustrated in one single plot for each parameter. This plot shows which configuration suits best the expectations of the designer.
More importantly, we can view the frequency response of the filter, and check up on its band- pass, for the different configurations of the screw. We can see that from the following figure, playing around with the screws’ dimensions can give us the best matching of the antenna
Figure 3: S21 Variations of the filter for different configurations
ElectroMagneticWorks Inc. 8300 St-Patrick, Suite 300, H8N 2H1, Lasalle, Qc, Canada +1 (514) 634 9797 | www.emworks.com
© 2012 ElEctroMagnEticWorks, Inc. All Rights Reserved.
ElectroMagnetic Design Made Easy
Powered By SolidWorks ©