dpg digital pressure gauge instructions - winters...
TRANSCRIPT
DPG Digital Pressure Gauge Instructions
Tel: 1-800-WINTERS / www.winters.com WINTERS INSTRUMENTS
Menu Button• Press -Changespressureunits (psi,mH2O,mmHg,mbar,kParanges≤100psi, psi,bar,kg/cm2,MPa,atmranges≥160psi)
Hold for 4 - 5 Seconds and Release• - Resettozero (Thisprocesswilltakeafewseconds)
Power Button• Press -TurnsgaugeONforabout1minuteanddisplays batteryreading.Backlight*willstayONfor10sec -TurnsgaugeOFF(holdfor2sec)
• Press While ON -Turnsbacklight*backONfor10sec
*backlightautomaticallycomesONwhenpressure changes±10%ofscale(whengaugeisON)
LCD Display
Battery Reading
Pressure Reading
Pressure Scale (units)
1. 2.
3. 4.
5.
To Change Batteries
1. Remove Rubber Boot
2. Remove Top Phillips Screw to Open Cover
3. Exchange Batteries (Two AAA Batteries)
4. Close Cover and Re-install Screw
5. Re-install Rubber Boot
DPGDigital Pressure Gauge Instructions
WINTERS INSTRUMENTS Tel: 1-800-WINTERS / www.winters.comMKT5164
12/14
Setup Options
HoldMenu Buttonforabout6seconds
A) Displaywillshow“tP-nP”
B) PressMenu Buttonanddisplaywillshow“Pot=X”.Thisselectsthenumberofdigitsafterthedecimalpoint.Press Power Buttontoselect“2or3”(forranges≤100psi)or“3or4”(forranges≥160psi).
≤100psi
Pot=2: -Nodigitsafterdecimalpoint(mmHg,mbar) -Onedigitafterdecimalpoint(kPa) -Twodigitsafterdecimalpoint(psi,mH2O)
Pot=3: -Onedigitafterdecimalpoint(mmHg,mbar) -Twodigitsafterdecimalpoint(kPa) -Threedigitsafterdecimalpoint(psi,mH2O)
≥160psi
Pot=3: -Nodigitsafterdecimalpoint(psi) -Onedigitafterdecimalpoint(bar,kg/cm2,atm) -Twodigitsafterdecimalpoint(MPa)
Pot=4: -Onedigitafterdecimalpoint(psi) -Twodigitsafterdecimalpoint(bar,kg/cm2,atm) -Threedigitsafterdecimalpoint(MPa)
C) PressMenu ButtonandDisplaywillshow“OFF=0”.ThisselectstheAutoorManualShutOffmodes.PressPower Buttontoselect“0”or“1”. OFF=0:AutoShutOffmode;DisplayautomaticallyshutsOFFafterabout1minute OFF=1:ManualShutOffmode;DisplaywillremainconstantlyONuntilShutOffmanually(thelifeofthebatteriesisabout 15days).
D) PressMenu ButtonandDisplaywillshow“HL=0”.ThisselectstheDisplaymode.PressPower Buttontoselect“0”or“1”.
HL=0: Displayshowsactualandcontinuousprocesspressure HL=1: Displayshowsonlypeakprocesspressure*
E) PressMenuButtontoreturntoprocesspressuredisplay
*GaugeneedstobecycledON/OFFtobereset