7/25/2019 DSE4120 Installation Instructions

1/2

With the unit in Stopmode,switch on the rear, bottom accidental operation

Once Configuration Mode isWhen in Configuration Mode

The Stop pushbutton can brequired function. The 5 left h

The Manual pushbutton will right-hand LEDs inform the u

When the required parametenew setting. The process is

When configuration is compreturned to the Normal pooverleaf on the Functions and

Exercise scheduler- Presswill run for 30 minutes, this wthe scheduler was set. Wheflash. To disable the scheduthe led above the Auto button

TYPICAL CONNECTIONS D E

4 1 2 0 I N S T A L

Normal mode Config

Deep Sea Electronics Plc.Highfield House, Hunmanby Industrial Estate, North Y

YO14 0PH.ENGLAND

Tel:+44 (0)1723 890099.Fax: +44 (0)1723 893303.

LO CALL (from UK BT landlines) :Telephone 0845 260 8900. Fax 0845 260 890

Email: sales@deepseaplc.comWeb: www.deepseaplc.com

7/25/2019 DSE4120 Installation Instructions

2/2

FUNCTIONS AND CONFIGURATION TABLE

Function 1

2 Value (Default in bold Italics)

0 Seconds 5 Seconds 10 Seconds 15 Seconds 20 Seconds 30 Seconds 60 Seconds

Pre-heat Timer

180 Seconds

0 Seconds 5 Seconds 10 Seconds 15 Seconds 20 Seconds 30 Seconds

60 Seconds

Start Delay

180 Seconds

0 Seconds 5 Seconds 10 Seconds 15 Seconds 20 Seconds 30 Seconds 60 Seconds

Stop Delay

180 Seconds

0 Seconds 5 Seconds 10 Seconds 15 Seconds 20 Seconds 30 Seconds 60 Seconds

Energise to Stop Timer

180 Seconds

0 Seconds 5 Seconds 10 Seconds

15 Seconds 20 Seconds 30 Seconds 60 Seconds

Warm-up Timer

180 Seconds

0 Seconds 5 Seconds 10 Seconds 15 Seconds 20 Seconds 30 Seconds 60 Seconds

Cooling Timer

180 Seconds

50 Hz O/S +14% / Oversho otNominal Frequency 60 Hz (O/S +14% / Overshoot +24%)

12V DC CF 8VNominal DC Voltage 24V DC (CF 16V)

Close on FaultLOP Switch Contact Open on Fault

Close on FaultHET Switch Contact Open on Fault

DisabledCrank disconnect on OilPressure

Enabled (2 Second Delay)

DisabledUnderspeed detection Enabled (U/S 20%)

Remote startRemote start function Simulated mains

Remote start is off loadRemote start on loadi nore if simulated mains

Remote start is on load

Immediate Warnin Close on Fault Immediate Warning Open on Fault Immediate Shutdown Close on Fault Immediate Shutdown Open on Fault Delayed Warning Close on Fault Delayed Warning Open on Fault Delayed Shutdown Close on Fault

Auxiliary Input 1 Function

Delayed Shutdown Open on Fault

Immediate Warnin Close on Fault Immediate Warning Open on Fault Immediate Shutdown Close on Fault Immediate Shutdown Open on Fault Delayed Warning Close on Fault Delayed Warning Open on Fault Delayed Shutdown Close on Fault

Auxiliary Input 2 Function

Delayed Shutdown Open on Fault

Not used Pre-heat Load transfer Common Warning Common Shutdown System in Auto Common Alarm

Auxiliary Output 1 Function

Energise to Stop

Not used Pre-heat Load transfer Common Warning Common Shutdown System in Auto Common Alarm

Auxiliary Output 2 Function

Energise to Stop

60V / 70V 70V / 80V 80V / 90V

90V / 100V 120V / 140V 140V / 160V 160V / 180V

Mains Under Voltage

180V /200V