duranium iphone xsmax · duranium case for iphone xs max using the holster 1 slidzphone into the...
TRANSCRIPT
Duranium Case for iPhone XS Max
- OVERVIEW -
Microphone hole
Silence Switch
Enclosed Volume Buttons
Soft Outer TPU Case
Scratch Resistant Clear Case Cover with Screen Protector
Polycarbonate Swappable Cover
Dust and Water-Resistant Charging Port Cover
1 6
7
2
3
4
5
123
4
5 6
7
1 Begin by separating the backplate from the soft body of the case.
2 Remove all protective �lm from case.
Peel Off
3 Starting from the corner, remove the soft TPU casing from the cover piece.
Peel Off
Soft Outer TPU Case
5 Press all around the sides and corners of the case making sure the cover is completely sealed in.
6
4 Place the phone into the cover piece with the screen facing the transparent window.
iPhone
Hard Cover
5 Working your way from the bottom, join the soft casing and cover back together. Make sure all ports and buttons are correctly aligned.
iPhone
Hard Cover
7 Insert the backplate starting from the bottom of the case.
8 Complete by then attaching the top two corners of the backplate to the soft case.
- INSTALLATION -
Page 1/2
Duranium Case for iPhone XS Max
USING THE HOLSTER
1 Slidzphone into the holster. Make sure to have the screen facing inward to avoid scratches when walking.
2 Gently snap the other side of the case into the holster. Make sure you feel the snap to ensure the case is locked into place.
PHONE CASEHOLSTER
UNINSTALLUse one hand to gently pull up on the holster’s release tab while the other hand gently pulls the case away from the holster.
USING THE KICKSTAND
PHONE CASEHOLSTER
While holding the clip open, slide down the locking mechanism to engage the lock for easy viewing, directly from the holster.
1 Begin by separating the backplate from the soft body of the case.
2 Gently pull away the rubber lip from the top piece of the case starting from the lower left corner.
Peel Off
Soft Outer TPU Case
Slightly Pullout the Corner
4 Working your way from the bottom, join the soft casing and cover back together. Make sure all ports and buttons are correctly aligned.
3 Slowly separate the two pieces of the case, then remove the iPhone from the top piece of the case as shown.
iPhone
Hard Cover
5 Press all around the sides and corners of the case making sure the cover is completely sealed in.
6 Insert the backplate starting from the bottom of the case.
7 Complete by then attaching the top two corners of the backplate to the soft case.
- UNINSTALL -
Page 2/2