e-zenith
TRANSCRIPT
-
8/7/2019 E-zenith
1/2
E-ZenithDescription:E-Zenith will challenge the participants spontaneity and his/her inventive instincts. Electronics
enthusiasts will find themselves at home as they are required to design and construct something
unique and worthwhile out of the provided junk machinery and equipment. Do you crave to play
around with electronics at every chance? Then this challenge is definitely your cup of tea.
The competitors will be given a limited time to perform a series of tasks, with the difficulty level
gradually increasing. The junkyard stuff provided could be anything from motors and dials, to
tin cans and spoons. Teams will battle in a knockout fashion of the top five ranks, and only the
most resilient of minds shall make it out as the winner.
Anticipation and improvisational abilities will be extremely essential. Moreover, E-Zenith goes
on to promote recycling and reusing such materials that prove to be one of the major contributors
to pollution.
Structure:The first four preliminary rounds will consist of tasks being released periodically.
Each task will be open to all teams for a maximum of 1 hour.
The difficulty level of the tasks will increase as the rounds progress. Results shall be announced
for the respective task on knock out basis.
Top four teams in the preliminary rounds will enter the final round where the team that
effectively completes the given challenge in the shortest amount of time will be the winner and
the subsequent, the runner-up.
If only one team manages to reach the last round then they will be considered the winners
without the necessity to complete the final round or simply the last team left standing before the
final round will be the winner.
The timing criteria might change upon the nature of the problems, whereas judgment criterion
remains the same.The decision of the jury will be full and final. Procom.Net 2011 www.procom.net.pk 17
-
8/7/2019 E-zenith
2/2
Rules and Regulations:
1. Each team consists of 1-4 participants.2. Each team member should be an on-going student at some University/Institute.3. Participation is open to everyone having the aptitude for electrical, mechanical and
electronic engineering.
4. Participants are requested to be equipped with some basic engineering tools like solderingirons, stand, DMMs (Digital Multi-meters) and screw driver toolkit, the rest of
components shall be provided as needed for the fulfillment of the assigned objectives.
5. The use of cell phones is prohibited during the competition.6. A team may be disqualified on the basis of cheating, misbehaving or not following any of
the specified rules. Moreover, the Procom Team has the rights to disqualify without
specifying the reason.
7. Final design will be judged on its simplicity and effectiveness.8. The decision of the judges shall be considered final and uncontestable.9. The timing criteria might change upon the nature of the problems, whereas judgment
criterion remains the same.
10.The Procom Team has the right to alter, add or remove rule(s) at any time. However theparticipant teams will be updated about the new rules in case of any change.
For any queries contact us at [email protected]