electrospray ionization (esi) matrix assisted laser desorption ionization (maldi) primary ionization...
TRANSCRIPT
Electrospray Ionization (ESI)Electrospray Ionization (ESI)
Matrix Assisted Laser Desorption Ionization (MALDI)Matrix Assisted Laser Desorption Ionization (MALDI)
Primary Ionization Techniques for Primary Ionization Techniques for MoleculesMolecules
LaserLaser
matrix + analytematrix + analyte
Sample supportSample support
aa
mm
mm
mm
mm
mm
mm
mmmm aa
aa
aa
aa
++
++
++
++mm
aamm++
Matrix Assisted Laser Desorption Matrix Assisted Laser Desorption Ionization (MALDI)Ionization (MALDI)
Matrix Assisted Laser Desorption Matrix Assisted Laser Desorption Ionization (MALDI)Ionization (MALDI)
h
Laser
+20 kV
Variable Ground Grid Grid
AH+
Sample plate1. Sample (A) is mixed with
excess matrix (M) and dried on a MALDI plate.
2. Laser flash ionizes matrix molecules.
3. Sample molecules are ionized by proton transfer from matrix:
MH+ + A M + AH+.
MALDI/TOF Mass SpectrumMALDI/TOF Mass SpectrumR
ela
tive
Abu
nda
nce
m/z
0
10000
20000
30000
40000
50000 100000 150000 200000
(M+H)+
(M+2H)2+
(M+3H)3+
MatrixMatrix
HO
CH C(CN)COOHOH
HO
COOH
HO
CH3O
CH3O
CH CHCOOH
-cyano-4-hydroxycinnamic acid 2,5-dihydroxybenzoic acid(2,5-DHB)
Sinapinic acid(3,5-Dimethoxy-4-hydroxy cinnamic acid)
HO
CH C(CN)COOHOH
HO
COOH
HO
CH3O
CH3O
CH CHCOOH
-cyano-4-hydroxycinnamic acid 2,5-dihydroxybenzoic acid(2,5-DHB)
Sinapinic acid(3,5-Dimethoxy-4-hydroxy cinnamic acid)
Sample Dilution/ConcentrationSample Dilution/Concentration•Dilute samples to the concentrations shown in the table below.
•If the sample concentration is unknown a dilution series may be needed to produce a good spot on the MALDI plate.
Compound Concentration
Peptides and proteins 0.1 to 10 pmol/µL
Oligonucleotides 10 to 100 pmol/µL
Polymers 100 pmol/µL
Note: highly dilute samples can be concentrated by Speed-Vac or Solid Phase Extraction.
Calibration of the mass scaleCalibration of the mass scale
The mass-to-charge ratio of an ion is proportional to the square of its time of flight in the analyzer (“drift time”).
2
22
L
Kt
z
m
t = Drift timeL = Drift lengthm = MassK = Kinetic energy of ionz = Number of charges on ion
h1. Sample (M) is mixed with
excess matrix (X) and dried on a MALDI plate.
The plate is loaded onto the sample stage in the Ion Source
Ground Grid
Sample plate
to Mass Analyzer
Sample & Matrix
MALDI:MALDI: Matrix Assisted Laser Matrix Assisted Laser Desorption IonizationDesorption Ionization
h
Laser
2. Laser flash produces matrix neutrals (X), matrix ions (XH)+, (X-H)- , and sample neutrals (M).
3. Sample molecules are ionized by proton transfer from matrix ions:
XH+ + M X + MH+.
X-H- + M X + M-H-
MALDI:MALDI: Matrix Assisted Laser Matrix Assisted Laser Desorption IonizationDesorption Ionization
h4. Ion Extraction:
High voltage is applied to the sample plate, accelerating ions out of the Ion Source into the Flight Tube.
MH+
+20 kV
MALDI:MALDI: Matrix Assisted Laser Matrix Assisted Laser Desorption IonizationDesorption Ionization
Flight Tube
Detector
Ion Source
Time-of-Flight Mass AnalyzerTime-of-Flight Mass Analyzer
Principle: If ions are accelerated with the same potential at a fixed point and a fixed initial time and are allowed to drift, the ions will separate according to their mass to charge ratios.
20-25 kV
++
Flight Tube
Detector
Ion Source
The ions enter the flight tube with the lighter ionstravelling faster than the heavier ions to the detector
+
+ +
Time-of-Flight Mass Analyzer
Flight Tube
Detector
Ion Source
The lighter ions strike the detector before the heavier ions.This “time of flight” (TOF) can be converted to mass
+
++
Time-of-Flight Mass Analyzer
Laser
Sampleplate
Analytemolecules in matrix
Accelerationgrids
Drift tube Ion detector
Mass spectrum
Vacuum system
Vacuumlock
Principle of MALDI-TOF-MSPrinciple of MALDI-TOF-MS
HiRes mass spectrum
Iondetector
MALDI ionsource
Ion reflector
The reflector focuses ion of same mass but different velocity on
detector; high resolution is obtained
Laser
High resolution TOF-MS with ion High resolution TOF-MS with ion reflectorreflector
Daughter ion mass spectrum
Iondetector
Ion reflector
MALDI ionsource
CID
MS/MS spectrum of daughter ionsis measured in a single acquisition;
no pasting of segments;low sample consumption,
high speed, high sensitivity
LID
Laser
TOF/TOF-MS/MS withTOF/TOF-MS/MS with
Parent ionselector
+
-1000 V -100 V
Primary Ion from Flight Tube
L
D= 6-25 u
Ions are detected with a Microchannel PlateIons are detected with a Microchannel Plate
+
-1000 V -100 V
L
D= 6-25 u
Ions are detected with a Microchannel PlateIons are detected with a Microchannel Plate
+
-1000 V -100 V
e-
L
D= 6-25 u
Ions are detected with a Microchannel PlateIons are detected with a Microchannel Plate
Multification by secondary emission
Secondary emissive materials: Beryllium oxide, magnesium oxide etc
+
-1000 V -100 V
e-e- e-
e-
L
D= 6-25 u
Ions are detected with a Microchannel PlateIons are detected with a Microchannel Plate
+
-1000 V -100 V
e-e- e-
e-
L
D= 6-25 u
Ions are detected with a Microchannel PlateIons are detected with a Microchannel Plate
+
-1000 V -100 V
e-e- e-
e-
L
D= 6-25 u
e-
e-
e-
e-
e-
e-e-
e-
~103
Amplification
Ions are detected with a Microchannel PlateIons are detected with a Microchannel Plate
Why interested in MALDI-TOF MSWhy interested in MALDI-TOF MS 분자량 측정
큰분자량 물질 분석
혼합물 분석 : 한 종류의 성분이 아닌 몇 종류가 혼재해 있어도 분석이 가능함
미량분석 : 매우 민감하여 미량의 시료도 분석 가능 함 : 펩타이드 경우 fmol 분석 가능
데이터 분석이 쉬움 : 분자 구조가 깨어 지지 않고 , 보통 다 전하를 (multiple charging) 띠지
않으므로 데이터가 다른 질량 분석기에서 보다 단순하여 해석이 용이함
염의 영향이 적음 : 생체단백질 분리에 이용되는 완충용액 , 염 등에 LC/MS 보다 영향을 덜 받음
분석이 신속함 : 시료와 Matrix 섞어 sample plate 에 떨어뜨려 용액을 말리는 시간 ( 약 5~10
분 ), MALDI-TOF 로 분석하는 시간 (1 분 이내 )
기기 사용 및 유지하기 위한 비용이 저렴 : LC/MS, GC/MS 처럼 질소 또는 아르곤 가스를 사용하지 않
고 , 미량의 Matrix 와 ACN, TFA 등을 이용함으로 시약 비용도 저렴함