Slide 1

FanBot is a fanning robot using High-speed DC Motor. Fan

Slide 2

1.Put 15mm Supports on Main Frame and fix with nuts. Put Small 3 Frame and Motor Guide on Main Frame and fix with 3x10 bolt, bolt and nuts. Assembling

Slide 3

2. Fix 7mm Supports to Contact Sensor Boards with bolts. Put LED Board on 7mm Support and fix with Nylon nuts. Assembling

Slide 4

3. Put Contact Sensor Board on Main Frame and fix with bolts and nuts. But for A1, A13, I1, I13, put 20mm Support under Main Frame and fix with nuts. Assembling

Slide 5

4. Fix 3x10 Bolts to Battery Case with nuts. Assembling

Slide 6

5. Fix 20mm Support to Small 8 Frame with bolts then fix Small 8 Frame to Main Frame. Put Battery Case under Main Frame and fix with nuts. Assembling

Slide 7

6. Connect 2 40mm Support then fix it to Motor Guide with 3x10 Bolt. Put Support that is fixed to Main Frame on CPU Board and fix with bolts. Assembling

Slide 8

7. Fix Motor Frame to Middle Frame with bolts. Fix 30mm Support as putting Middle Frame in between. Assembling

Slide 9

8. Fix High-speed DC Motor to Motor Frame that is fixed to Middle Frame with bolts. Fix DC Motor and DC Motor Drive Board to Support that is fixed to Middle Frame with nuts and bolts. Assembling

Slide 10

9. Put Middle Frame on Support that is fixed to Motor Guide and fix with Nylon nut. Assembling

Slide 11

10. Fix 20mm Support to Wheel Guide and Small 5 Frame with a bolt and a Nylon nut. Insert Wheel Guide to DC Motor axle then fix Small 5 Frame to Support that is fixed to Small 8 Frame with a Nylon nut. Assembling

Slide 12

11. Fix Motor Frames to High-speed DC Motor then put Remocon Receiving Board on it and fix with bolts. Assembling

Slide 13

12. Put 7mm Supports on a Wheel Guide and fix with 3x10 Bolts. Assembling

Slide 14

13. Just insert Option Frames to Support that is fixed to a Wheel Guide (not fixing with bolts or nuts) and fix with 3x10 Bolts and Nylon nuts. Assembling

Slide 15

14. Stick Double-stick tapes to Option Frame then stick Fan Wings. Insert Wheel Guide to DC Motor axle. Assembling

Slide 16

15. Connect Power Cable of Battery Case to Power Connector of CPU Board. Connect High-speed DC Motor and DC Motor cable to DC Motor Drive Board A, B. Assembling

Slide 17

16. Connect 3Pin Cable to OUT Port 1, 2, 3, 4 of CPU Board and LED Board. Connect 3Pin Cable to OUT Port 5, 6, 7, 8 of CPU Board and 1, 2, 3, 4 of DC Motor Drive Board. Assembling

Slide 18

17. Connect 3Pin Cable to IN Port 1, 2, 3, 4 of CPU Board and Contact Sensor Board. Connect 3Pin Cable to IN Port 7 of CPU Board and Remocon Receiving Board. Assembling

Slide 19

18. Completed FanBot. Assembling