TH72015/11/12 Evaluation Board

New Melexis EVAL BOARD

Enables Next-Generation

Wireless Applications

A monthly selection of the latest products from EEWeb

FEATURED PRODUCTSNovember 2014S U P P L E M E N T

2 eeweb.com/register

Join Today

FEATURED PRODUCTS SUPPLEMENT

3

TH72015/11/12 Evaluation Board

New Melexis EVAL BOARD Enables Next-Generation Wireless Applications

The EVB72015 is an evaluation board designed for FSK/ASK transmitter operating at 433-MHz frequency. It features an on-chip low voltage regu-lator with high over-all frequency accuracy typically used in general digital data transmission.

The evaluation board is designed to demonstrate the performance of the transmitter IC with an on-board loop antenna. This board allows the user to setup an RF transmitter very easily. Alternatively, a 50 Ω connector board can be requested.

FEATURES• Fully integrated PLL stabilized VCO• Frequency range from 380 MHz to 450 MHz• Single-ended RF output• FSK through crystal pulling allows modulation from DC to 40 kbps• High FSK deviation possible for wideband data transmission• ASK achieved by on/off keying of internal power

amplifier up to 40 kbps• Wide power supply range from 1.95 V to 5.5 V• Very low standby current• On-chip low voltage detector• High over-all frequency accuracy• FSK deviation and center frequency independently adjustable• Adjustable output power range from -12 dBm to +10 dBm

(connector board)• Adjustable effective radiated power (ERP) range

from -24 dBm to -2 dBm (at antenna board)• Adjustable current consumption from 3.4 mA to 10.6 mA• Conforms to EN 300 220 and similar standards

Read More at EEWeb Tech Community

4

Automotive Stop/Tail LED Array DriverAllegro’s A6264 is an automotive stop/tail LED array driver that was released since 2009. Unlike A6262, the A6264 doesn’t have an on/off toggle switch input. The device is ideally suitable for automotive tail, stop, and turn lights. It provides up to 100 mA for each of four outputs to drive arrays of high brightness LEDs. The LED current can be switched between high current and low current for stop/tail applications...Read More

30 W Ultraminiature Switching Power SuppliesThe MSMC-0300 is a single output power supply that is offered in a DIN rail mount kit. It produces 25 W of rated power through a voltage output of 3.3 V and a current output of 7.5 A. Input voltage range of the device is at 90 – 264 VAC and has a user-friendly on/off control and DC voltage adjust. The power supply also includes over current, over voltage, and short circuit protection...Read More

Low Cost ChipLEDThe APDS-9002 is Avago Technologies’ low-cost analog-output ambient light photo sensor in a cost-effective miniature chipLED. It has a lead-free surface mount package. It provides an excellent responsivity that is close to the response of a human eyes. The APDS-9002 is ideal for applications in which the measurement of ambient light is used to control display backlighting...Read More

Low Power Portable Audio DACThe CS43L22 is a portable audio DAC with integrated Class-D speaker driver featuring high performance stereo DAC and digital signal processing engine. It does not require external filter and offers flexible clocking options with I2C control port operation...Read More

FEATURED PRODUCTS SUPPLEMENT

5

RS-232 EMI Filter ModulesThe RS-232 EMI Filter Modules of Coilcraft are filter modules that offer easy and effective way to eliminate stray EMI in signal cables. It features common mode magnetics filter at all lines including frame ground available in 3 DB versions. Coilcraft’s EMI filter modules are an easy, effective way to eliminate the problems of stray electromagnetic interference (EMI) in signal cables running between poorly filtered equipment...Read More

GeneSiC Schottky RectifiersGeneSic signed an agreement, together with Digi-Key, for the global distribution of its products. GeneSic’s low-capacitance silicon carbide (SiC) Schottky rectifiers are now globally available. These rectifiers are specifically designed for voltage multiplier circuits and high voltage assemblies which are commonly used in a wide range of x-ray, laser, and particle generator power supplies...Read More

SuperFET® II FRFET® MOSFETThe FCP150N65F is an advanced super-junction MOSFET that has a drain to source voltage (Vdss) of 650 V. Its gate threshold voltage (Vgs) range is as low as 3 – 5 V for a fast turn-on. The device also has a static drain to source on resistance (Rds) of as low as 133 – 150 mΩ for an optimized switching capability...Read More

Ultra-miniature Signal RelayThe FTR-B4 series is Fujitsu’s ultra miniature slim profile signal relay. It has 2 poles, 8 pin DIP, contact rating of 0.01 mA to 1 A, and coil values from 1.5 V to 24 V. This relay is best suited for use in navigation (sound) and dark current cut...Read More

6

Receiver for Optical Distance MeasurementThe MAX3806 is the industry’s first 130 dB dynamic range transimpedance amplifier with switchable gain and nA sensitivity. The device is a preamplifier that consists of a selectable-gain transimpedance amplifier, a selectable 14 dB attenuator, and an output-driver block. The selectable-gain transimpedance amplifier linearly boosts the signal from the photodiode...Read More

Flexible Transparent Elastomer SystemMaster Bond’s EP30D-10 elastomer offers abrasion and chemical resistance while maintaining high flexibility and strength. It is a versatile system for your most demanding applications like bonding, sealing, encapsulating, and casting. EP30D-10 cures at room temperature or even more rapidly at elevated temperatures. It has an exceptionally wide service range and has been used successfully at cryogenic temperatures...Read More

Low Drive Power Multifunction SwitchThe XS170 is a multifunction telecom switch featuring low drive power requirements in a small 8-pin package. It is typically used in telecommunications, instrumentations and industrial controls available in surface mount package...Read More

Compact Synchronous Buck RegulatorThe ISL8025 is a compact synchronous buck regulator that operates in an input voltage range from 2.7 V to 5.5 V with a continuous output current of 5 A. This step-down DC/DC converter is highly efficient with up to 95% efficiency, and pin-to-pin compatible with ISL8023 and ISL8024. The device employs current mode control architecture for a very low duty cycle operation at high frequency with fast transient response and excellent loop stability...Read More

FEATURED PRODUCTS SUPPLEMENT

7

Altera MAX® 10 FPGA Evaluation BoardMouser Electronics, Inc. announced the availability of Altera’s Non-volatile MAX 10 FPGA evaluation boards designed to support test and development of the new Altera FPGA’s. It features Enpirion Power Solutions, as well as an integrated flash memory, embedded RAM and embedded DSP all in one die....Read More

250 W Single Output AC/DC Power SuppliesThe MPU-250F is a series of AC/DC power supplies that have an input voltage range of 90-132 VAC or 180 – 264 VAC, depending on the model of choice. The devices have an input frequency range of 47 – 63 Hz and an output regulation of ±1.0%. Isolation voltage of the four standard models is as high as 3000 VAC. These U-channel power supplies are also equipped with internal fan for better cooling mechanism...Read More

Serial Quad I/O™ SuperFlash® MemoryMicrochip Technology introduced the SST26WF016B, a 1.8 V Serial Quad I/O™ (SQI) SuperFlash® Memory device family. The SST26WF016B provides 16-Mbit of memory and is based on Microchip’s high-performance SuperFlash technology with fast erase times and superior reliability...Read More

Overcurrent and Surge Current ProtectionMurata introduces its PTGL series with a tight tolerance of 30 V. It is composed of 14 part numbers with different specifications. Specifications such as resistance values at 25 ˚C, maximum current, hold and trip current, and dimensions vary from one part number to the other...Read More

8

Dual CMOS ComparatorThe HA1631D01/02/03/04 is a dual CMOS, push-pull/open drain output comparator featuring low supply current and low voltage operation. If offers low input offset voltage, as well as low input bias current...Read More

High Class 3000 Watt Power SupplyThe PFE3000-12-069RA is a high class power supply that is both an AC/DC and DC/DC converter, perfect to use on applications requiring high accuracy. This power supply is rated with platinum-level efficiency, best-in class version that guarantees to meet the high standards of the industry today...Read More

IEC 62368 Certified X-Capacitor Discharge ICsPower Integrations successfully meet the IEC 62368 standard on its CAPZero™ family of innovative, two-terminal, automatic X-capacitor discharge ICs. The IEC 62368 is the new over-arching safety standard covering TVs and IT equipment. The CAPZero family eliminates power losses while allowing power supplies to comply with safety standards. The new standard replaces IEC 60950 and IEC 60065 and will become mandatory...Read More

High Speed Dual Unbuffered InverterThe 74HC2GU04-Q100 is a high-speed dual unbuffered inverter. This device has been certified by the Automotive Electronics Council (AEC) standard Q100 (Grade 1) and is intended for automotive applications. It operates in a broad supply voltage range from 2.0 V to 6.0 V. It features high noise immunity, ESD protection, low power dissipation, and balanced propagation delays...Read More

FEATURED PRODUCTS SUPPLEMENT

9

Economic Level Digital OscilloscopeThe MSO1104Z-S is a mixed signal oscilloscope that belongs to RIGOL’s MSO1000Z Series. This instrument has a 100 MHz bandwidth and features 4 analog channels that has sample a rate of up to 250MSa/s when all the channels are utilized. The oscilloscope also has a standard maximum memory depth of 12 Mpts and can capture waveforms up to 30,000 wfms/s...Read More

12V/250mA Output DC/DC ConverterAnother type of isolated DC/DC converter by ROHM Semiconductor is the BP5324A. This DC/DC converter can achieve switching power supplies with the use of few peripherals. This kind of converter is convenient to match with drivers for microcomputers, relays, and LEDs...Read More

Street Lighting Electronic BallastsTE Circuit Protection introduces a component suited for electronics lightning ballast protections, the FT600-2000-2. It is a telecom fuse with a rated current of 2 A, maximum interrupt voltage of 600 VDC, and maximum interrupt current of 60 A. It is commonly used in Street Lighting Elecronic Ballasts...Read More

CMOS Amplification ICZMDI has designed a CMOS IC suited for amplification and sensor-specific correction of bridge sensor signals, the ZSSC31150. It accommodates virtually any resistive bridge sensor, like steel membrane based pressure sensors.ZSC31150 has been designed for automotive applications and is specifically suited for most pressure sensors...Read More

Sierra Circuits:A Complete PCB Resource

PLUS: The Ground ” Myth in PrintedCircuits

“

PCB Resin Reactor+

Ken BahlCEO of Sierra Circuits

Let There Be

How Cree reinvented the light bulb

LIGHT

David ElienVP of Marketing & Business

Development, Cree, Inc.

New LED Filament Tower

Cutting Edge Flatscreen Technologies

+

+

M o v i n g T o w a r d s

a Clean Energy

FUTURE— Hugo van Nispen, COO of DNV KEMA

MCU Wars 32-bit MCU Comparison

Cutting Edge

SPICEModeling

Freescale and TI Embedded

Modules

ARMCortex

Programming

From Concept to

Reality Wolfgang Heinz-Fischer

Head of Marketing & PR, TQ-Group

Low-Power Design Techniques

TQ-Group’s Comprehensive Design Process

+

+

PowerDeveloper

Octobe r 20 13

Designing forDurability

View more EEWeb magazines— Click Here