Fitting guide for the Land Rover Range Rover Evoque Please check all the fixings before you start fitting the side steps.

Name Quantity

Side Step 2

Front Bracket 2

Rear Bracket 2

10mm U-bolt + Fixings 2

12mm T-Bolt + Fixings 4

If you think you are missing any of the components in the list above, please contact Direct 4x4 for further advice.

Step 1: Get the Range Rover Evoque on the ramps (If possible) Step 2: Rear Bracket. The photo below shows the bracket fitted onto the passenger side. The fitment is the same for both driver and passenger sides.

This is what the rear bracket will look like this from the side.

Step 3: Front Bracket

This is another angle of what the Front Bracket will once it has been fitted.

Step 4: Attaching the boards

Loosen all of the 6mm nuts which are under the running boards. Then position them to match nup

with the brackets.

Place the boards onto the brackets so that the 6mm bolts drop down through the brackets.

Then use the washers and nuts to tighten up.

Products Care:

You can use most cleaning solutions on the market.

NOTE: Do not use any cleaning solutions with either TFR chemical or other brake cleaning chemicals.

You will need to regularly clean the steps to keep them in any good condition.