fitting instructions for ryco cabin filter rca194p holden captiva (cg) series … · 2018-07-17 ·...
TRANSCRIPT
FITTING INSTRUCTIONS FOR RYCO CABIN FILTER RCA194PHOLDEN CAPTIVA (CG) SERIES I & SERIES II
INSTRUCTION SHEET IS194P
GUD Automotive Pty Ltd29 Taras Ave Altona NorthVictoria 3025 Australiawww.ryco�lters.com.au
GUD (NZ) Holdings Limited626A Rosebank Road AvondaleAuckland, New Zealandwww.ryco.co.nz
GUD Automotive - A Division of
1Filter is located behind glove box. Remove glove box toacces cabin filter housing.A regular size Phillips screw driver and a small flathead screw driver will be required to perform the job.
2
Remove the bottom screws of the glove box as indicated.
3
Once bottom screws are removed proceed to openglove box and remove the top screws as indicated on theimage. Then gently pull the glove box out untilconnectors are seen.
Remove the top connector first by gently pulling it. Then tiltforward glove box to reach for rear connector. You mayneed a small flat head screw driver to release.
Once glove box is out of the way it will bevery easy to identify cabin air filter housing.
4
Identify cabin air filter housing which will be sitting ontop of air blower. Proceed by removing screw onhousing lid and remove to acces filter.Remove filter and clean housing of any dirt or leaves.
Identify cabin air filter housing which will be sitting ontop of air blower. Proceed by removing screw onhousing lid and remove to acces filter.Remove filter and clean housing of any dirt or leaves.
Replace cabin air filter by inserting it in the right air flowdirection as indicated. See filter frame to identify directionin which filter has to be fitted. Refit all previously removedcomponents in reverse order.
5 6