fitting instrutions - tyga-performance · 2016. 6. 7. · the msx125sf has a belly pipe as...
TRANSCRIPT
![Page 1: FITTING INSTRUTIONS - TYGA-Performance · 2016. 6. 7. · The MSX125SF has a belly pipe as standard, so for fitting the TYGA High level pipe it is necessary to modi-fy the standard](https://reader035.vdocument.in/reader035/viewer/2022071503/6122c1980fa5b059d611708b/html5/thumbnails/1.jpg)
MAKING YOUR DREAMS A REALITY
FITTING INSTRUCTIONS
Rear Fender Modification for:
High Level Exhausts HONDA MSX125SF / Grom
EXPS-0065, EXPS-0066 and EXPS-0067
![Page 2: FITTING INSTRUTIONS - TYGA-Performance · 2016. 6. 7. · The MSX125SF has a belly pipe as standard, so for fitting the TYGA High level pipe it is necessary to modi-fy the standard](https://reader035.vdocument.in/reader035/viewer/2022071503/6122c1980fa5b059d611708b/html5/thumbnails/2.jpg)
The MSX125SF has a belly pipe as standard, so for fitting the TYGA High level pipe it is necessary to modi-
fy the standard rear fender to fit the stay (BPSY-0175 / BPSY-0177), which is used to secure the silencer in
position.
* The first modification is to cut a small slot for the stay to protrude out to allow the silencer to be
mounted.
* The second modification requires removing material from the piece on the inside of the rear fender. A
paper template is provided for performing this modification.
The modifications are the same for both BPSY-0175 and BPSY-0177.
BPSY-0177
First, modify the outer piece:
1. Mark out the trim lines to the dimensions as show
2. Drill a couple of 6mm holes at either end of the slot marked
3. Use a file or modeling knife to trim to size
BPSY-0175
![Page 3: FITTING INSTRUTIONS - TYGA-Performance · 2016. 6. 7. · The MSX125SF has a belly pipe as standard, so for fitting the TYGA High level pipe it is necessary to modi-fy the standard](https://reader035.vdocument.in/reader035/viewer/2022071503/6122c1980fa5b059d611708b/html5/thumbnails/3.jpg)
Now, modify the inner piece:
1) Cut out the paper template provided.
2) Offer up template to part and mark off as necessary. Use tape or scribe a line.
3) Cut out part as shown.
Offer up BPSY-0175/0177 to check fit and clearance. And trim any interference as necessary.
1
2
3a 3b
![Page 4: FITTING INSTRUTIONS - TYGA-Performance · 2016. 6. 7. · The MSX125SF has a belly pipe as standard, so for fitting the TYGA High level pipe it is necessary to modi-fy the standard](https://reader035.vdocument.in/reader035/viewer/2022071503/6122c1980fa5b059d611708b/html5/thumbnails/4.jpg)
Maggot EXPS-0065 only
The bush provided for the Maggot (EXPS-0065) goes between the stay (BPSY-0175) and the mounting tab
on the Maggot with the mounting tab on the Maggot on the outside
More products for the new MSX125SF / Grom