Flanged with Opposite Side Support Installation InstructionsQuick Installation Guide00825-0200-4809 rev. DB – 48500825-0100-4585 rev. AA – 585

Mark the Locations for Drilling the Mounting Holes Mark the location for the first hole Use a pipe tape to find and mark the location of

the opposite side hole

Drill the Holes into the Pipe Using a Drill Bit or Hole Saw

Tag with correct drill hole size attached to the Annubar

The mounting holes must be 180° degrees apart to ensure

Hole Sizes for Each Annubar Type485

585

Clean the Area with a Grinder to Prepare for the Surface for Welding

Mounting Should be Welded So the Bolt Holes Straddle Pipe Center Line The mounting

hardware should be gapped 1/16th inch for welding– Use weld rod to do this

It should also be centered over the drilled hole

Tack Weld the Mounting Hardware with 4 Equal Length Tacks Tack weld anywhere on

the mounting hardware Then again directly across

from the first tack weld Then on the other 2 sides

2

1

3

Check to See that the Mounting Hardware is Level and Square If it’s not, use a

rubber mallet to lightly adjust the hardware and recheck

Verify that the ODF Dimension Matches What is Listed in the QIG The ODF is the dimension from outside pipe diameter to face of flange

485 585

Verify that the ODF Dimension Matches What is Listed in the QIG The ODF is the dimension from outside pipe diameter to face of flange

Complete a Continuous Weld Around the Perimeter of the Unit

Insert the Annubar Sensor to Align the Opposite Side Support (OSS)

Round tip of the Annubar

Sockolet or threadolet

Welded or threaded OSS Plug

The tip of the Annubar should engage the OSS Support Plug a minimum of ½ inch

Gap the Threadolet or Sockolet 1/16” and tack weld it into place With the Annubar

inside

Remove the Annubar and Complete a Continuous Weld Around the Sockolet or Threadolet

Weld or Thread the Opposite Side Support Plug

Insert the OSS Plug into the Sockolet, then gap it 1/16” (provides socket weld gap) and tack weld it in place. Then complete a continuous weld around the OSS Plug.

Welded OSSThreaded OSS

The Annubar Sensor should not be installed for this step (This would cause irreparable damage to the Annubar)

First wrap the threads with the appropriate tape sealant. Then thread the OSS Plug into the threadolet.

Insert the Annubar With the appropriate gasket Verify the flow arrow on the side of the Annubar

is pointing in the right direction

Tighten the Bolts in a Cross Pattern to Appropriate Torque Specification