flatbelt/dyno + windtunnel method 12.11.2014 rld with flatbelt/dyno and wind tunnel, oit #10 and #18...
TRANSCRIPT
FLATBELT/DYNO + WINDTUNNEL METHOD
12.11.2014
RLD WITH FLATBELT/DYNO AND WIND TUNNEL, OIT #10 AND #18
WLTP-08-22e
Page 2
WLTP FLATBELT PLUS WIND TUNNEL CONCEPTINTRODUCTION
WLTP flatbelt/dyno plus wind tunnel concept, 03.11.2014
Within the windtunnel / Annex 4 TF a road load determination method using a wind tunnel and a flatbelt or dynamometer is developed.
What makes this method attractive is the fact, that it can be used independently of weather or temperature conditions over the whole year.
Timeline: Vienna: Starting note and first
proposal Further developed at two f2f
meetings (Munich and Delft).
State of play, details on next slides:
Wind tunnel: BMW Flat belt: VW Dyno: UTAC Validation measurements: PFA
Page 3
WLTP FLATBELT PLUS WIND TUNNEL CONCEPTSTATUS AND STRUCTURENo. Paragraph Status
Target for Pune
6.Road load measurement using a wind tunnel and a chassis dynamometer or flatbelt facility draft available
to be discussed
6.1. Description of method
6.2. Approval of facilities draft availableto be
confirmed
6.3. Vehicle preparation and temperature draft availableto be
confirmed
6.4. Wind tunnel measurement
draft availableto be
confirmed
6.4.1.
Wind tunnel criteria
6.4.2.
Wind tunnel measurement
6.5. Flatbelt measurement
draft availableto be
discussed
6.5.1.
Flatbelt criteria
6.5.2.
Flatbelt measurement
6.6. Chassis dynamometer measurement
work in progress @UTAC
-
6.6.1.
Chassis dynamometer criteria
6.6.2.
Chassis dynamometer measurement
6.6.3.
Chassis dynamometer specific calculations
6.7. Calculations
draft availableto be
discussed
6.7.1.
Correction of flatbelt and chassis dynamometer result
6.7.2.
Calculation of the aerodynamic force
6.7.3.
Calculation of road load values
WLTP flatbelt/dyno plus wind tunnel concept, 03.11.2014
Page 4
WLTP FLATBELT PLUS WIND TUNNEL CONCEPTSUMMARY AND QUESTIONS TO THE IWG Please consider these additional documents:
First draft proposal on parts of this method by BMW. First concept and draft proposal on measuring on the flatbelt by VW. (First) results from PFA validation program by UTAC.
There was significant progress since the first proposal in Vienna.
First parts of the method are discussed and already drafted.
The windtunnel TF asks the IWG to either confirm or give a direction of improvement of the proposals - part by part, in order to give guidance to the task force where to focus.
Additional participants in the TF are asked to inform the contact persons (Rob Cuelenaere and Christoph Lueginger).
WLTP flatbelt/dyno plus wind tunnel concept, 03.11.2014