flow simulation in solidworks 2011
TRANSCRIPT
Flow Simulation in Solidworks 2011
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Create a model. Save it. Then click on “add-ins” as shown.
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Select Solidworks flow simulation and click on “ok”
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Click on “Flow Simulation” available on the top.Select “wizard”
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Create new-> configuration name
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Select the unit->next
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Select the analysis type as “external”. Select the boxes of “consider closed cavities->next
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Give a velocity along x direction->next
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Configuration domain-> change the wall size according to the requirement.
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Right click on “goal”->insert global goals
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Check your requirements
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Again click on “RUN”
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Wait till the solver has finished solving.
Created by Abhijeet Kumar Sahu for educational and non profitable use.
“flow simulation”-> right click-> insert
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Select the choices as per your requirements.
Created by Abhijeet Kumar Sahu for educational and non profitable use.
Right click on the solution obtained under “flow simulation”->play (to see the simulation)
Created by Abhijeet Kumar Sahu for educational and non profitable use.