0,25 mt

10,00 mt

sat receiving antenna

solar panel

sun shield

SMART FM - TRX INNOVATE

battery

antenna

General SpecificationsDescription

Rural Transmission Site Installation Example

http://www.trxinnovate.comsales@trxinnovate.com

FM Smart Transmitter

- FM 87.5 to 108 MHz

- RJ45 feed through waterproof connector for data stream and control- RF F type connector 75 Ohm to sat antenna- DC 12/24/48 V MIL-STD connector

- RF N type connector 50 Ohm

- 5 to 25 W (depending on options)

- Multi-carrier transmission

- ≤ 100W @24V (depending on options)

- Operating range 0° to 60°C - Storage range -10° to 75°C

- Outdoor unit (ODU module): 442 x 312 x 165.5 mm (~15kg)

- Ground Plane- Torch

- Radio spectrum ETSI 300-384; ETS 302-018- EMC ETSI 447; ETS 301-489- Safety EN 60950 - EN 60215

Thanks to the new digital technologies, all the hardware of a complete transmission station can now be integrated into a single equipment. Smart-FM by TRXInnovate is the highly compact solution that allows you to have all the functions of an FM transmission site in a single, mast-mounted, small-sized box.

Low power consumption, low electromagnetic pollution, quick & easy installation are the key features that make our equipment the best choice for FM area coverage.

Our cell-based model allows to cover vast territories in a smart way by transmitting the signal only to the needed areas, using low-power transmitters and avoiding to waste power and money to cover unnecessary areas. Moreover, it also allows for scalable investments, whose economic return would be impossible to achieve with the traditional business model.

Operation frequency range

Input

Output

Power

Other options

Supply

Environmental data

Dimensions

Antenna options

Standard compliance

The technology developed by TRXInnovate allows to set up totally self-sufficient transmission stations by using either mono- or bi-directional satellite distribution, with a power supply obtained by means of alternative energy sources (the example shows a photovoltaic panel + battery configuration).

Thanks to the integrated control platform, the whole transmitter network can easily be managed and configured remotely from a single place.

0,25 mt

10,00 mt

sat receiving antenna

solar panel

sun shield

DVB-T / TRX INNOVATE

battery

antenna

General Specifications*Description

http://www.trxinnovate.comsales@trxinnovate.com

TV Smart Transmitter

- UHF/VHF

- RJ45 feed through waterproof connector for data stream and control- RF F type connector 75 Ohm to sat antenna- DC 24/48 V MIL-STD connector

- RF N type connector 50 Ohm

- 3 to 10 W for single ODU module

- ≤ 300W (depending on options)

- Operating range -15° to 60°C - Storage range -15° to 75°C

- Outdoor unit (ODU module): 442 x 312 x 165.5 mm

- Low power Superturnstile

Thanks to the new digital technologies, all the hardware of a complete transmission station can now be integrated into a single equipment. Smart-DVBT by TRXInnovate is the highly compact solution that allows you to have all the functions of a DVB-T transmission site in a single, mast-mounted, small-sized box.

Low power consumption, low electromagnetic pollution, quick & easy installation are the key features that make our equipment the best choice for DVB-T area coverage.

Our cell-based model allows to cover vast territories in a smart way by transmitting the signal only to the needed areas, using

low-power transmitters and avoiding to waste power and money to cover unnecessary areas. Moreover, it also allows for scalable investments, whose economic return would be impossible to achieve with the traditional business model.

Operation frequency range

Input

Output

Power

Supply

Environmental data

Dimensions

Antenna

Rural Transmission Site Installation Example

The technology developed by TRXInnovate allows to set up totally self-sufficient transmission stations by using either mono- or bi-directional satellite distribution, with a power supply obtained by means of alternative energy sources (the example shows a photovoltaic panel + battery configuration).

* all options and configurations to be defined during the contract and network designing phase.

Thanks to the integrated control platform, the whole transmitter network can easily be managed and configured remotely from a single place.

Description

http://www.trxinnovate.comsales@trxinnovate.com

FM Digital Network Adapter

The FM Digital Network Adapter by TRXInnovate is intended for the “retrofitting” of existing analog FM stations, converting them into FM digital distribution stations in a quick and easy way. This allows the broadcasters to protect their past investments, keeping their sites operational while re-converting the existing transmitters to the latest digital technologies, without having to get rid of the old analog stations (which can be “retrofitted” thanks to our technology) and without having to invest in new and expensive full-digital ones.

In order to support the highest number of existing analog stations, whose configuration can vary quite a lot, we provide a wide range of inputs and outputs, which are compatible with most existing systems.

Thanks to the integrated control platform, the whole transmitter network can easily be managed and configured remotely from a single place.

Key Features

Internal Block Diagram

General Specifications

- ≤ 100W @24V (depending on options)

- Operating range 0° to 60°C - Storage range -10° to 75°C

- 1Rack Unit

- Radio spectrum ETSI 300-384; ETS 302-018- EMC ETSI 447; ETS 301-489- Safety EN 60950 - EN 60215

Supply

Environmental data

Dimensions

INPUTS: - satellite dish (DVB-S/S2) - IP streaming (supports VLAN, UDP, UDP + error correction) - direct ASI input - GPS PPS for SFN sinchronization

OUTPUTS: - 0dBm RF FM modulated signal (embedded RDS coder, stereo coder, UECP demux) - MPX 100 KHz modulated signal (embedded RDS coder, stereo coder, UECP demux) - up to 4 synchronous audio decoders (SFN) - up to 4 AES EBU digital audio outputs - up to 4 balanced analog audio outputs - up to 4 UECP demultiplexed outputs

Standard compliance

Key Features*Description

FM Radio-based Event Warning and Emergency Alert System

- all 87.6-108 MHz or 87.5-107.9 MHz(103 channels with 200 KHz spacing)- RJ45 feed through waterproof connector for data stream and control- DC 24/48 V MIL-STD connector

- RF N type connector 50 Ohm

- 50/100 mW per channel (depending on options)*

- 200/500 W (depending on options)*

- 24 VDC (depending on options)*

- Operating range -15° to 60°C - Storage range -15° to 75°C- 100m / 1 Km coverage (depending on options)*

- Outdoor unit (ODU module): 442 x 312 x 165.5 mm- Groundplane or Directive (depending on options)*

The heart of the system is a multi-frequency FM transmitter which can send emergency warnings and alert signals on all radio frequencies simultaneuosly (88 - 108 MHz band) within 50-100 m from its position, temporarily covering the standard radio signal in order to transmit the warning to all the vehicles within that range. According to statistics, about 74% of drivers listen to the radio while at the wheel: our technology uses this media to reach those people and quickly notify them the emergency warnings or alert messages in a safe and effective way. Moreover, it can also be used for public order messages, law enforcement needs, or civil defense warnings.

The system is extremely compact and doesn’t need any expensive additional infrastructures. It can be mounted in fixed positions (highways, road tunnels, etc.) or on mobile posts (to alert people about temporary roadworks, accidents, traffic jams, etc.).

Operating frequency range

Inputs

Output

RF Power Out

Power Consumption

Power Supply

Operating Range

Dimensions

Antenna

System Installation Examples

Cool Feature

* all options and configurations to be defined during the contract and network designing phase.

It can transmit an audio message, a voice alert or other messages. Thanks to embedded RDS encoder, it uses the “Traffic Alert” function to make the radio switch automatically to the FM tuner, transmitting the alert signal both as an audio message and as an RDS text. Even if the driver is listening to a CD or an MP3, the receiver with an active RDS Traffic Alert warning will automatically switch to the FM tuner in order for the alert to be heard.

The system can also be installed in emergency or rescue vehicles to quickly alert the nearby drivers about the approaching of these vehicles. It can be either activated directly by the rescue vehicle personnel in case of an emergency coming from a mobile post, or remotely from the headquarters, in case of use in a fixed position.

This FM Alert system can be connected to an environmental sensor network: when a dangerous event is detected, an alert signal is automatically transmitted on all FM frequencies with an active RDS Traffic Alert warning.

http://www.trxinnovate.comsales@trxinnovate.com