focus: frequency compensation: audiologist guide · audiologist guide for adjusting zvox ......
TRANSCRIPT
®
Audiologist Guide for Adjusting ZVOX Audio AV205
The AccuVoice AV205 is a compact amplified speaker system created by ZVOX Audio for the audiology profession. With the AV205, an Audiologist can provide a client with a compact TV sound system configured for the client’s specific audio needs.
The AV205 features the ability to switch between three sound modes using the ACCUVOICE button on the client’s remote control. Repeated presses of the ACCU-VOICE button selects AC_1 and AC_2 and then the normal surround mode (desig-nated by Sd). The programmed AccuVoice mode (AC_1) is created by the Audiolo-gist. Standard AccuVoice mode (AC_2) helps people with minor age-related hearing loss. The SURROUND button sets which of three multi-channel sound modes is used (Sd_1, Sd_2 and Sd_3). Refer to the User Manual of the AV205 for further information about the controls available on the standard AV205 remote control.
The Audiologist uses the ZVOX Audio Audiology Remote to make the adjustments described below. This remote control is available separately for the Audiology profession and should be retained by the Audiologist. Each AV205 comes with standard remote control, which provides volume, mute and tone adjustments plus selection of the digital or analog input. A diagram of each remote follows.
ZVOX Audio Audiology Remote
ZVOX Audio AV205 Standard Remote
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
4
SURROUND
ACCUVOICE VOLUMEOUTPUTLEVELING
INPUT CLEARREVIEW
COMPRESSION
BASS REDUCTION
FREQUENCY COMPENSATION
VOICE
FOCUS
AUDIOLOGYThe AV205 has five separate adjustment categories that apply to AC_1 mode:
FOCUS provides three levels of increasing emphasis on dialog, with a correspond-ing reduction of music, sound effects and other background sounds.
VOICE adds an adjustable amount of synthetic harmonic content to dialog (specifically to “formants”) to better suit the remaining hearing capability of a client. There are four increasing levels.
FREQUENCY COMPENSATION provides three increasing amounts of emphasis centered on 4500 Hz. Both amplitude and bandwidth increase with higher settings.
BASS REDUCTION reduces output below 500 Hz. This eliminates distracting ele-ments of wide-range sound that can interfere with dialog intelligibility.
COMPRESSION provides four levels of restricted volume variation. It increasingly forces all program material to be played at the single output level set by the volume control.
Once the five parameters are set by the Audiologist, he or she can review the five settings by repeated presses of the REVIEW button. The CLEAR button returns all settings to the defaults.
How to adjust the AV205You need the Audiology Remote to adjust the AV205.
Make sure the AV205 is connected to AC power. To turn on the AV205, you can press the POWER button on the AV205 endcap, press the POWER button on the
standard AV205 remote, or press either VOLUME button on the Audiology Remote.
VOICE: Choose one of four levels for VOICE. You will see the following displays when you choose VOICE level one, two, three or four:
, , ,
Each setting adds synthetic harmonic content to formants in the audio program. This can increase dialog intelligibility for a client.
FREQUENCY COMPENSATION: Choose one of three levels for FREQUENCY COMPENSATION. You will see the following displays:
, ,
Each setting of FREQUENCY COMPENSATION increases the audio program content centered at 4500 Hz.
BASS REDUCTION: Choose one of three levels for BASS REDUCTION using the three buttons. You will see the following displays:
, ,
Each increased setting of BASS REDUCTION removes more audio content below 500 Hz.
COMPRESSION: Choose one of three levels for COMPRESSION using the three buttons. You will see the following displays:
, ,
COMPRESSION restricts variation in audio program output level.
ALL CATEGORIES: A category that was not adjusted will show a zero when the settings are reviewed—
, , , , .
DYNAMICRANGE
CPS1
HIGH OUTPUT
LOWOUTPUT
CPS2 CPS3
Adjustments:FOCUS: Choose one of three levels for FOCUS using the three buttons. You will see the following when you choose FOCUS level one, two or three:
, ,
Increasing the FOCUS setting reduces parts of the multi-channel audio program that are not monaural. The vast majority of dialog on multi-channel TV, video and movie programming is monaural, so this selectively removes distracting program material.
OU
TP
UT
FREQUENCY
FUNDAMENTAL
OU
TP
UT
FREQUENCY
SYNTHESIZEDHARMONICS
OU
TP
UT
FREQUENCY
FCP34500 Hz
FCP2
FCP1
500 Hz
bAS1, -3 dB
-0 dB
bAS2, -6 dB
bAS3, -9 dB
OU
TP
UT
FREQUENCY
VIRTUAL SURROUNDEFFECT LEVEL
VIRTUAL SURROUNDEFFECT LEVEL
VIRTUAL SURROUNDEFFECT LEVEL
LEFT
LEFT
LEFT
CENTER
CENTER
CENTER
RIGHT
RIGHT
RIGHT
MAIN SPEAKER LEVEL
MAIN SPEAKER LEVEL
MAIN SPEAKER LEVEL
www.zvoxaudio.com | [email protected]
About ZVOX AudioThe AV205 is a product of ZVOX Audio, a company specializing
in convenient single-cabinet sound systems for TVs. ZVOX Audio
SoundBase and soundbar products are unique in providing easy-to-
connect, single-cabinet solutions for better TV sound. The optical digital
and analog audio inputs on the AV205 insure it easily connects to virtually
any HDTV. In addition, the AV205 can respond to the client’s preferred
remote control, not just the supplied ZVOX Audio remote.
The AccuVoice AV205 allows audiologists and hearing aid dispensers to fine-tune five different parameters to suit
individual patients’ needs. This guide provides recommended setting based on an individual’s audiogram.
Recommended Settings Based On Audiogram ConfigurationsThe following configurations can be used for various degrees of hearing loss. Use the suggested settings below and vary the volume to compensate for the amount of amplification needed. Press the Clear button to reset to the default settings.
Focus
FrequencyCompensation
AccuVoice
VolumeAdjustent Range
Compression
Bass Reduction
Voice
Increase if there is background noise in the room
Increase high frequency output by 3 dB per step
Reduce low frequency output by 3 dB per step
Amount of dynamic range limitation
Use to improve speech discrimination
Vary according to Hearing Level
1
1 or 2
1
1
AV205 Feature Symbol Setting Condition1 or 2
1 or 2
FOC
ICE
FCP
bAS
CPS
1-30
AC1,AC2
Frequency (Hz)
30
40
50
60
7080
90
100
110
120
130
140125 250 500 1000 2000 4000 8000
20
10
0-10
Hea
rin
g L
evel
(dB
)
Focus
FrequencyCompensation
AccuVoice
VolumeAdjustent Range
Compression
BassReduction
Voice
Increase if there is background noise in the room
Increase high frequency output by 3 dB per step
Reduce low frequency output by 3 dB per step
Amount of dynamic range limitation
Use to improve speech discrimination
Vary according to Hearing Level
2
2
1 or 2
1 or 2
1
1, 2 or 3
AV205 Feature Symbol Setting ConditionFOC
ICE
FCP
bAS
CPS
1-30
AC1,AC2
Frequency (Hz)
30
40
50
60
7080
90
100
110
120
130
140125 250 500 1000 2000 4000 8000
20
10
0-10
Hea
rin
g L
evel
(dB
)
Frequency (Hz)
30
40
50
60
7080
90
100
110
120
130
140125 250 500 1000 2000 4000 8000
20
10
0-10
Hea
rin
g L
evel
(dB
)
Focus
FrequencyCompensation
AccuVoice
VolumeAdjustent Range
Compression
Bass Reduction
Voice
Increase if there is background noise in the room
Increase high frequency output by 3 dB per step
Reduce low frequency by 3 dB per step
Amount of dynamic range limitation
Use to improve speech discrimination
Vary according to Hearing Level
2 or 3
3
2 or 3
1 or 2
2
1, 2or 3
AV205 Feature Symbol Setting ConditionFOC
ICE
FCP
bAS
CPS
1-30
AC1,AC2
Frequency (Hz)
30
40
50
60
7080
90
100
110
120
130
140125 250 500 1000 2000 4000 8000
20
10
0-10
Hea
rin
g L
evel
(dB
)
Focus
FrequencyCompensation
AccuVoice
VolumeAdjustent Range
Compression
Bass Reduction
Voice
Increase if there is background noise in the room
Increase for improved speech sharpness
Amount of dynamic range limitationVary according to Hearing Level
2 or 3
3 or 4
3
On
3
1, 2or 3
AV205 Feature Symbol Setting ConditionFOC
ICE
FCP
bAS
CPS
1-30
AC1,AC2
Focus
Frequency Compensation
AccuVoice
Volume Adjustent Range
CompressionBass Reduction
Voice
Use if sound distorts or echoes
Limits dynamic rangeVary according to Hearing Level
32
1 or 2
On
1 or 21
AV205 Feature Symbol Setting ConditionFOCICE
FCP
bASCPS
1-30
AC1, AC2
Suggestions for using Compression [CPS]Using this feature ensures the level of sound produced by the device will be restricted (compressed) to fit the dynamic range requirement of a client. Here are examples of the effect of the three settings:
Please note that it is likely that the output level will increase when CPS is activated. The client’s preferred volume level setting will decrease as the CPS level increases.
If the client uses a hearing aid, the following settings are recommend as a starting point for improved intelligibility.
Frequency (Hz)
30
40
50
60
7080
90
100
110
120
130
140125 250 500 1000 2000 4000 8000
20
10
0-10
Hea
rin
g L
evel
(dB
)
Frequency (Hz)
30
40
50
60
7080
90
100
110
120
130
140125 250 500 1000 2000 4000 8000
20
10
0-10
Hea
rin
g L
evel
(dB
)
Frequency (Hz)
30
40
50
60
7080
90
100
110
120
130
140125 250 500 1000 2000 4000 8000
20
10
0-10
Hea
rin
g L
evel
(dB
)
Frequency (Hz)
30
40
50
60
7080
90
100
110
120
130
140125 250 500 1000 2000 4000 8000
20
10
0-10
Hea
rin
g L
evel
(dB
)
no CPS
CPS1
CPS2
CPS3
AccuVoice AV205 Speaker
Adjustment Guide.