8/2/2019 Forgotten Password

1/2

FrequentlyAskedQuestions

app l i es t o P r oduc t DD5/DD10/DD20/DD30

Question

What can you do when you forget the Password ?

Answer

Enter the ACCESS menu and toggle down with the Soft key USER (underneath the name of the activated user)

to the next on this switcher installed ``USER`` and press soft key LOGIN.

In case the soft key USERS (see top side of the menu) appears then press the corresponding pushbutton.*) Now

you will get a list of all the installed USER. Toggle with the arrow-buttons to that USER which you can not

login, because of the unknown password. In the column ``Passwd`` you would have ``NO`` for no password or``YES`` for when a password would be necessary.

Now select with the soft key PERMIT (right hand upper side) the same permission which this user had before

and press soft key ENTER. In the column Passwd it changes from YES to NO.

Now it should be possible to login the original USER without entering a password.

*) In case the soft key USERS does not appear continue toggling to the next installed USER until you get an

USER with SYSTEM permission.

Background information: Only a SYSTEM user is authorised to delete a password of any other USER and only

he would have the soft key USER with the list of all the USER available.

In case there is only one USER with SYSTEM permission available there would be no direct possibility for

deleting the password.

If this is fact please proceed by the following:1st possibility: Connect the PC to the Service-Port of the E-Box (Service connector on front of the E-Box

controller RY 1917 or at rear side of the E-Box).

Cable necessary 9pin

pin2-------------pin2

pin3-------------pin3

pin5-------------pin5

or 1:1 cable except pin7 and pin 9 connected

necessary Software: MS-KERMIT or other Terminal emulation program (VT102; Hyper terminal)

Please refer also to the Service manual 4.2 SERVICE MENU; Connecting a PC

Call KERMIT.exe; type C for connect; push the SPACE pushbutton at the PC; the Service menu appears.Choose INTEGRATED ERROR DIAGNOSIS by typing I at the PC, then choose CLEAR RAM FILES by

typing C and choose QUERY by typing Q. Now the first file which could be deleted would appear and you

would be asked for clear process by YES or NO. Type ``Y`` for Yes (use capital letters otherwise your entry

would be ignored) at the file named ACCESS; All other positions must be answered with ``N`` for No. The

RAM content will be cleared at the position ACCESS, respectively set to default; Only the user COMMON with

permission SYSTEM will appear. All other USER must be re-entered.

2nd possibility is much more easier to carry out but with the result that more settings would be lost.

It is to perform an "emergency clear ".

Doing this by pressing the RESET switch on the E-box controller RY 1917. If

all LEDs of the bar are lit, press the push button which is close to the RESET button

(named MONITOR or 1TERM) and hold it down until the LEDs are running again in normal operation.

ATTENTION; this would clear the file contents of: ACCESS, CONF-EB andSTATE-EB. The most important set-ups would be lost: Aux couple, Prerouter and DVE set-ups, port protocols,

Genlock phase, Col-Limiter, EXTRA Define-memo.

8/2/2019 Forgotten Password

2/2

Send E- m a i l f o r m o r e i n f o r m a t i o n a n d

c o m m e n t

Techn ica l Suppo r t Sw i t che r s

E-mai l :

TechSuppo r t Sw i t che r @t h m u l t i . com

Copyright (c)2000, Philips Br oadcast