freightliner m2 standard installation overview...j1939 splice block – years 2016 and newer if...
TRANSCRIPT
Freightliner M2
Standard Installation Overview
Page | 2
M2 – Optional Power Pins
Two pins are recommended for the power connections on M2 vehicles. These pins are available online from many
sources: search on the pin number listed below.
If no pins are available, the wires can be 3-way spliced into the feeds coming off each splice block.
Power – Delphi Part 12191818-L Ignition/Ground – Delphi Part 12110844-L
Page | 3
M2 – Display
The display RAM mount attaches to the dash just above the passenger’s side cup-holder.
Page | 4
PMG
The PMG mounts behind the passenger’s side dash panel. The exact location will vary depending on
vehicle year and accessories. Some versions may require cutting the dash panel ribs to make room.
Page | 5
Antenna
Page | 6
Battery Power and Ground
The Battery Power and Ground blocks are located under the dash top panel near the center of the cab.
Page | 7
Battery Power and Ground
NOTE: The Power/Ground/Ignition connections can often be made without removing the cap from the
vehicle connection
Page | 8
Ignition Sense
Page | 9
Engine Data Overview
Page | 10
J1708/1587 Data Connection – Pre-2011 Model Year
The J1708/1587 signal line was the original primary data circuit. It was phased out over time but should be
connected any time it is available as a complement and back-up to the newer J1939 circuit.
Page | 11
J1939 Data Connection – Pre-2016 Model Year
NOTE: There may be multiple vehicle 1939 connectors available in the noted location. Any of those connectors can
be used.
Page | 12
J1939 Splice Block – Years 2016 and Newer
Beginning in 2016 Daimler switched to a 500K J1939 circuit as primary. The pre-2016 location has that connection, identified
with white stripes on the yellow and green leads, plus a “500K” label. On those vehicles, the PeopleNet J1939 will connect to
the 250K circuit splice block, available under the dash top panel and in the glovebox area.
Page | 13
J1939 Splice Block – Years 2016 and Newer
If available, splice Delphi part number 12110844* pins to the yellow and green leads of any of the J1939 pigtails in the L-016-0153 kit
and proceed to the next page. If not, follow these instructions to use the pins available in the International/Navistar Pigtail.
*Pins can be ordered online from several sources. Search “DELPHI 12110844” for options.
Page | 14
J1939 Splice Block – Years 2016 and Newer
Page | 15
Optional PLC Trailer Tracking Connection
The PLC Trailer Tracking connects to the Trailer Power position of the Trailer Fuse Panel behind the driver’s seat using a Mini-ATC Add-a-Circuit
Page | 16
Optional PTO Connection
The Factory M2 PTO is multi-plexed. If PTO is desired and the unit has a factory switch,
connect to an airline following the recommendations in the Support Center PTO guide
If the vehicle has a non-factory PTO switch, test the switch and light looking for a 12 volt or
Ground switched output to connect
Page | 17
Video Intelligence Install Overview
Page | 18
Factory-Wired M2 Fuse
By customer request, factory installed M2s are delivered with no power fuse inserted. Follow these
instructions to power the device.