Page 1
Fujitsu Large Wall Mounted
Disassembly instruction
Page 2
Once the front cover is removed the three front
screws can be accessed. Remove the three screws
located in the front of the unit.
FRONT
Page 3
Remove the plastic screw covers, then remove the
three screws located at the bottom of the unit.
Bottom
Page 4
After removing the cover, remove the three
screws as indicated.
Page 5
Remove these screws from the top right of the
unit and also lower right of the unit.
Page 6
Remove these two screws on the left side of
the unit. After removing these two screws the
coil and the drip pan assembly will separate.
Page 7
Make sure that the units bottom rear mounting
clips are detached from its wall bracket.
Page 8
Separate the coil from the drain pan assembly.
Evaporator
Coil
Blower Wheel &
Drain Pan Assembly
Page 9
Remove these four screws on the fan motor
housing , then remove the housing.
Page 10
Remove set screw, then blower wheel and fan
assembly should separate.
Page 11
Separate and remove blower wheel and fan
motor.
Blower
wheelFan Motor