gear steering - justanswerww2.justanswer.com/uploads/supermechanic/2012-01... · 1/17/2012 · 8....
TRANSCRIPT
Gear Steering
Special Service tools
Steering Wheel Locking Tool 211-263
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
1 of 11 1/17/2012 8:38 AM
Separator Ball Joint 204-192 (JD-219)
Removal
All vehicles
Disconnect the battery ground cable.1.
RHD vehicles
Center the steering wheel.2.
Lock in position and remove the ignition key.
LHD vehicles (if required)
CAUTION: Install the special tool to the lower steering column to maintain a straightahead steering wheel position. Failure to do so may cause damage to the steeringwheel clockspring.
3.
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
2 of 11 1/17/2012 8:38 AM
Install the special tool to the lower steering column.
All vehicles
Loosen the lower steering column slider pinch bolt.4.Remove both front wheels and tires. For additional information, refer to Tires andWheels.
5.
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
3 of 11 1/17/2012 8:38 AM
Disconnect the actuator electrical connector.6.
Detach the lower steering column.7.
Remove the steering gear shaft pinch bolt.
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
4 of 11 1/17/2012 8:38 AM
CAUTION: Whenever the steering gear unions and hoses are disconnected thesteering gear valve body ports and hoses should be plugged to prevent dirtingress.
8.
Disconnect the power steering supply and return tubes.
Drain the fluid into a suitable container.Remove and discard the O-ring seals.
NOTE: RH shown, LH similar.9.
Remove both the tie rod ends retaining nuts.
Remove and discard the retaining nuts.
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
5 of 11 1/17/2012 8:38 AM
CAUTION: When the tie rod end is separated from the wheel hub assembly, the balljoint seal should be protected to prevent damage.
10.
NOTE: RH shown, LH similar.
Using the special, detach both the tie rod ends from the wheel hub assemblies.
Vehicles with 4.0L engine
Detach the steering gear supply and return tubes.11.
All vehicles
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
6 of 11 1/17/2012 8:38 AM
Remove the steering gear.12.
Installation
All vehicles
Install the steering gear.1.
Tighten to 103 Nm .
Vehicles with 4.0L engine
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
7 of 11 1/17/2012 8:38 AM
Attach the steering gear supply and return tubes.2.
All vehicles
CAUTION: Install new retaining nuts.3.
NOTE: RH shown, LH similar.
Connect both the tie rod ends.
Tighten to 75 Nm.
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
8 of 11 1/17/2012 8:38 AM
NOTE: Install new O-ring seals.4.
Connect the power steering supply and return tubes.
Tighten to 10 Nm .
Install the steering gear shaft pinch bolt.5.
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
9 of 11 1/17/2012 8:38 AM
Tighten to 35 Nm .
Connect the actuator electrical connector.6.Install both front wheels and tires. For additional information, refer to Wheels andTires.
7.
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
10 of 11 1/17/2012 8:38 AM
Tighten the lower steering column slider pinch bolt.8.
Tighten to 35 Nm.
LHD Vehicles (if Required)
Remove the special tool from the lower steering column.9.
All Vehicles
NOTE: When the battery has been disconnected and reconnected, someabnormal driving conditions may occur while the vehicle relearns its drivingstrategy. Connect the battery ground cable.
10.
Install a new power steering reservoir, for additional information, refer to PowerSteering.
11.
The content of this article/image reflects the changes identified in TSB-ST211-006
Replace the power steering reservoir only if any of the following conditions apply:1.
Reservoir bottle housing is split
Reservoir bottle port is crushed
Fluid is grossly contaminated with particulate matter, witch may or may not resultin a loss of function from the power steering system.
If particulate contamination is observed, but the steering system functions normally,drain the fluid from the system, replace the reservoir, and flush the steering systemcompletely with fresh fluid.
2.
Check and adjust front wheel alignment. For additional information, refer to12.
ALLDATA Online - 2000 Jaguar S-Type (X200) V6-3.0L - Steering Gear http://www.alldatapro.com/alldata/PRO~V237894171~C40453~R0~OD...
11 of 11 1/17/2012 8:38 AM