Guy Greetings Card

Page 1

All images © 1990-2017 Stampin’ Up!®

lavenderthoughts.wordpress.com

Supplies:

• Stamp Sets – Guy Greetings (WM 138825, CM 138828, PP 137178) • Card Stock/DSP – Urban Underground DSP (142783), Silver Foil (132178), Basic

Black A4 (121688) • Stamp Pads – Versamark (102283) • Misc. – Stitched Shapes Framelits (145372), Big Shot (143263), Stampin’ Trimmer

(129722), Embossing Buddy (103083), Silver Stampin’ Emboss Powder (109131), Heat Tool (129056), Multipurpose Liquid Glue (110755), Stampin’ Dimensionals (104430).

Measurements: • Urban Underground DSP at 3” x 6” or 7.5cm x 14.5cm • Silver Foil at 2-7/8” square or 7.3cm square • Basic Black

o Card base (I’ve used C6 size) o cardstock scrap at 3” square or 7.5cm square – to fit largest square framelit

Guy Greetings Card

Page 2

Instructions:

1. Adhere Urban Underground DSP to card front to the left to leave a black border down the right hand side. Use Multipurpose Liquid Glue or the glue of your choice. You can make 8 card fronts per 12”x12” sheet of DSP or 96 from a full pack!

2. Using Big Shot & Stitched Shapes Framelits Dies to cut the largest square in Basic Black.

3. Use the Embossing Budding to prep the Basic Black square you’ve just die cut. Don’t worry about it leaving a white mark on the cardstock, you can wipe it off after you’ve embossed it.

4. Use the Versamark to stamp the sentiment & image of your choice, sprinkle with Silver Embossing Powder & set with the Heat Tool. Allow to cool & then rub on a soft, clean piece of material to remove any excess Silver Embossing Powder or Embossing Buddy Powder.

5. Use Dimensionals to attach the Basic Black square you’ve just embossed to the Silver Foil square & then adhere to the center of the card front with Tombow Multipurpose Glue or the glue of your choice.