FR

AN

ÇA

IS

AU

VE

RS

O

2020/07/09 DIV3016A

HAND SPLIT SHAKESUMMARY INSTALLATION GUIDE Shake

See www.tandobp.com for the complete installation guide.

CAUTION: ALWAYS INSTALL PRODUCT FROM LEFT TO RIGHT AND REMEMBER THAT POLYMER UNDERGOES EXPANSION/CONTRACTION DUE TO TEMPERATURE VARIATIONS. FOR A BETTER LOOK WE RECOMMAND TO INSTALL PRODUCT ON FLAT SURFACES (EX: PLYWOOD PANELS OR OSB PANELS). IF SECTIONS ARE INSTALLED ON A WALL WITH FURRINGS, FURRING STRIPS MUST BE INSTALLED OBLIQUELY AND SPACED BY 8”(20,32CM).

When using TandoShakeTM corners. When used with J-channel or outside corner.

1/16”(0,16cm)

Outside corneror J-channel

1/4”(0,64cm)

2

For full length section.

Maximum 8’’(20,32cm) between each nails.

x 6

3

For each nail.Fasten each section at its center.

When installing a cut section, nail in its center as shown.

When installing a full section, nail in the center hole first.

1/16’’(0,16cm) Minimum Minimum

7/16’’7/16’’(1,11cm)(1,11cm)

Minimum Minimum 1 1/2’’1 1/2’’

(3,81cm)(3,81cm)

4

6

Alternate the joints between rows.

7

If you need to attach the section in an area other than the installation hole, create a 1”(2,54 cm) long slot to allow nailling. Always nail in the middle of the slot.

1’’(2,54cm)

Center

12 3/8”

(6,03cm)

1/2”(1,27cm)

8’’ MAX.(20,32cm)

Floor

Wall

1/2”(1,27cm)

1 2 33 1/2”(8,89cm)5 Install sections and space equally according to the outside temperature when installing and the temperature chart below.

Over 90°F(32°C) : 3/8”(0,95cm)Between 90°F(32°C) and 60°F(15°C) : 1/2”(1,27cm)

Below 60°F(15°C) : 5/8”(1,59cm)

8 CORNER INSTALLATION

First TandoShakeTM corner. Next TandoShakeTM corners.

1 2 3 4

3/8’’(0,95cm)

1/4’’(0,64cm)