hook case eng usa
TRANSCRIPT
-
8/18/2019 Hook Case ENG USA
1/2
-
8/18/2019 Hook Case ENG USA
2/2
Designed by Rosaura Valdez
ch2, 5sc in 2nd ch from hook. (5 sts).
Mark
the
end
of
the
rounds.
: 2sc, inc, 2sc. (6 sts)
6 inc. (12 sts)
1sc around. (12 sts)
[1sc, inc] 6 times. (18 sts)
1sc around. (18 sts)
[8sc,
inc]
2
times.
(20
sts)
To make the hook
10sc, ch3, skip next 10 sts and
continue with the next round.
10sc, 1sc on each ch. (13 sts)
1sc around. (13 sts)
[2sc, dec] 3 times, 1sc. (10 sts)
[1sc, dec] 3 times, 1sc. (7 sts)
1sc around. (7 sts)
Cut yarn leaving a small tail to close the
gap.
‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐
To make the body.
Rejoin the yarn to the first stitch you
skipped doing the hook .
[2sc, inc] 3 times, 1sc, 1sc in the
corner formed, 3sc on the opposite side
of the 3ch made for the hook, 1sc in the
other corner. (18 sts)
1sc around. (18 sts)
Fill just this part with stuffing and
continue working.
1sc around. (18 sts)
At this point, it is better to place the
lining (previously folded and sewn to fit
inside the hook) and insert the container
or soda lid at the bottom (This is to avoid
the hooks get hooked in the yarn or
fabric).
To make the smooth part of the center
of the hook, some stitches are working
as back post single crochets (bpsc). Make
these stitches loose so your hook
doesn’t shrink a lot. As we are working
in spiral, the lines are going to look a
little slanted.
7sc, 6bpsc, 3sc. (Incomplete row.
Move your marker to consider this the
end of
this
row,
keep
marking
from
here).
[6bpsc, 3sc] 2 times. (18 sts)
Repeat round 17. (18 sts)
Continue working for 15 more roun
until the desired length.
1sc around. (18 sts).
‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐
To make the lid
ch2, 6sc in 2nd
ch from hook. (6
6 inc. (12 sts)
[1sc, inc] 6 times. (18 sts)
[8sc, inc]
2
times.
(20
sts)
1sc around. (20 sts)
To make the buttonhole
5sc, ch2, skip next 2 sts, 13sc. (
5sc, 1sc on each ch, 13 sc. (20 s
Cut yarn leaving a tail to sew to the
of the hook.
‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐
To make up.
Tie the cord to the lid and add
something to give strength to this p
(add lining to the lid too, or use a p
of plastic or a button of the size of
bottom of the lid). You will need it
because yarn can be deformed wit
weight of the hooks. Sew the lining
the top of body, place the button 2
rows below the top, and sew the b
the lid to the back of the hook. Tak
your hooks, put them inside your h
and all ready to go!
Materials:
I
used
Acrylic
yarn
(8ply,
less
than
1oz);
a
little of stuffing material; a 3mm crochet
hook; one button; a little craft container (1
inch diameter) or a standard plastic soda
lid; a cord or ribbon (7 inch); a piece of
fabric for the lining (approx. 6.3 x 4 inch);
sewing needle and scissors.
Finished size: 1.5 x 8.5 inch
bbreviations: ch (chains), sc (single crochet), inc (increase: 2sc in same stitch), dec (decrease: 2sc together), bpsc (back post single croch