how to install “eternity iv cylinder” with “handle” onto ......
TRANSCRIPT
1
How to install “Eternity IV Cylinder” with “Handle” onto the Lock
Step 1. Attention to “Shaft in vertical position“ Step 2. Take key out from Cylinder
Step 3. Put Cylinder into “outside handle”(w/hole), then Step 4. Hold key with cylinder & insert handle,
insert key into Cylinder from outside handle position & press tight onto lock
Step 5. Turn key “counter-clockwise” & pull out key
Shaft in vertical
position
Cylinder w/Key
Turn cylinder
position bar & match
to step 1. while
installing onto lock
Make sure both position should match
together while put onto lock
Also see below picture