hp refill_932.933.950.951_is-5000sk-v2.4
TRANSCRIPT
-
7/24/2019 HP Refill_932.933.950.951_IS-5000SK-V2.4
1/6
IS-5000SK-V2.4 Data is subject to change without notice
5869 Terminal Ave, Colorado Springs, CO 80915Ph: 800.688.0129 or 719.578.0506 |www.rjettek.com
HP InkJet CartridgeRefill Instructions(For #5000SK Kit)
Specific Cartridges:
932, 932XL, 933, 933XL, 950, 950XL, 951,951XL
http://www.rjettek.com/http://www.rjettek.com/http://www.rjettek.com/http://www.rjettek.com/ -
7/24/2019 HP Refill_932.933.950.951_IS-5000SK-V2.4
2/6
Refill InstructionsHP 932/933/950/951 Cartridges Revised: 02/02/2015
HP Refill_932.933.950.951_IS-5000SK-V2.4 Page 2of 6 Data is subject to change without notice
Contents of Kit:
- (4) each #1950, 10cc Syringe- (4) each #1953, 20cc Syringe- (1) each #1952, 60cc Syringe- (4) each #1905, Cannula Needle (Dual Side Port Blunt Plastic Needle)- (4) each #1959, Syringe Tip
- (25) each #LAB104, Label, Quality Remanufactured Ink Jet Cartridge- (1) each Pushpin- Inks: 8 ounces of Black, 4oz Cyan, 4oz Magenta, and 4oz Yellow
Cartridge # Color Ink #
932 Black BKP280
933 Cyan CP280
933 Magenta MP280
933 Yellow YP280
950 Black BKP280
951 Cyan CP280
951 Magenta MP280
951 Yellow YP280
Approximate Weights and Fill Volumes
Cartridge # Color Empty Wt Ink Amount Full Wt
932 Black 20 13ml 33
932XL Black 38 32ml 70
933 C/M/Y 20 6ml 26
933XL C/M/Y 20 13ml 33
950 Black 48 38ml 86
950XL Black 48 80ml 128
951 C/M/Y 26 13ml 39
951XL C/M/Y 27 25ml 52
CartridgesYou will need to have 2 sets of cartridges for this refill method to work correctly in your printer (unless replacement chips are
used). See Ink Cartridges Depleted message on page 5.
Replacement Chips(not included in this kit)The replacement chips, which can be purchased separately from R-JetTek, will allow you to refill and use only one set of
cartridges. The replacement chips will also provide ink levels. Chip replacement instructions can be found on page 6.
Warning: Do not use the Starter/Setup cartridges that came with the printerThe Starter Cartridges may fail in the customers printer due to the chip being marked as Depleted, and this condition may
not be recoverable for the starter cartridge.
Caution:To prevent damage to the chips follow common ESD safety procedures - for example see:http://en.wikipedia.org/wiki/Electrostatic_discharge
http://en.wikipedia.org/wiki/Electrostatic_dischargehttp://en.wikipedia.org/wiki/Electrostatic_discharge -
7/24/2019 HP Refill_932.933.950.951_IS-5000SK-V2.4
3/6
Refill InstructionsHP 932/933/950/951 Cartridges Revised: 02/02/2015
HP Refill_932.933.950.951_IS-5000SK-V2.4 Page 3of 6 Data is subject to change withoutnotice
Refill Process
HP 932/933/950/951
Syringe Tip Preparation:Using a Pushpin youwill need to punch a hole in the plastic SyringeTip on each side about 1/16 from the tip (See
Figure 1). This will prevent the Syringe Tip fromsealing against the exit port sealing ball.
1. Place the plastic Syringe Tip with thepunched holes onto the 10ml syringe.
2. A)For 932, 932XL, 933XL, and all 950 and951 Cartridges: Holding the cartridge withthe Exit Port (see Figure 2) on the bottom,insert the plastic Syringe Tip into the ExitPort of the cartridge and pull back on thesyringe to remove old ink (see Figure 3).Caution: Be careful not to dislodge therubber bushing on the exit port.
B) For 933 Regular Cartridges Only:Note:The 933 regular color cartridges haveno pressure relief port like the others, so itwill create a vacuum in the cartridge. Toovercome this do the following: Using thesame tools as in A aboveinsert the syringetip as in Figure 3, and pull back on plunger.Empty the waste ink from syringe. Next,place the plunger on the syringe betweenthe 6 and 8mm marks (just air), and insertas in Figure 3, but this time inject the air intothe cartridge. Now pull back on the syringeand you will pull out the air along with the
remaining ink. You may have to repeat afew times to remove it all.
3. Attach the Cannula Needle (Figure 4) to the20 or 60ml syringe (depending on whichcartridge you are filling), and fill it with thedesignated amount of ink. See fill amountsabove. Caution: DO NOT exceed fillamounts
4. Place the cartridge with the port facing uponto a firm surface. Insert the CannulaNeedle at a slight angle into the Exit Port ofthe cartridge and fill the cartridge with ink
(Figure 5). Caution: DO NOT press thesyringe against the port too hard as this willform a seal between the port and the needlepreventing air from escaping. If pressuredevelops move the syringe to release.
5. Place the cartridge with the port facing uponto a firm surface.
6. Insert the 10ml syringe with the plasticSyringe Tip into the Exit Port of the cartridgeand slowlypull back on the syringe until inkappears in the syringe (see Figure 6). This
will remove any excess air from thecartridge. Warning: If the cartridge is notprimed correctly it may flood the printheadinside the printer.
Figure 4
Figure 2
Figure 3
Figure 6
Figure 5
Figure 1
-
7/24/2019 HP Refill_932.933.950.951_IS-5000SK-V2.4
4/6
Refill InstructionsHP 932/933/950/951 Cartridges Revised: 02/02/2015
HP Refill_932.933.950.951_IS-5000SK-V2.4 Page 4of 6 Data is subject to change withoutnotice
Error MessagesWhen using refilled 932/933/950/951 Cartridges you may receive one of the following error messages:
Used or Counterfeit Cartridges DetectedIn this case click on No and continue. The samemessage appears for both the Black and Color cartridges.
Used, Refilled or Counterfeit Cartridge DetectedMissed Rewards This is a typicalScare Message. If you receive this message just click on OK and your printer will continueprinting.
-
7/24/2019 HP Refill_932.933.950.951_IS-5000SK-V2.4
5/6
Refill InstructionsHP 932/933/950/951 Cartridges Revised: 02/02/2015
HP Refill_932.933.950.951_IS-5000SK-V2.4 Page 5of 6 Data is subject to change withoutnotice
Error Messages Continued
Ink Cartridges Depleted You may run into this message when a cartridge that was removedfrom the printer, refilled, and then is placed back into the printer. The printer has marked thiscartridge on the chip when it becomes empty. You can overcome this issue by obtaining asecond set of cartridges, and replace the cartridge in question. Once this secondary cartridge isused up replace it with the first cartridge that generated the Ink Cartridge Depleted message,and it should work fine. Continue to do this Leap-Frog method with each cartridge.
Additional Error MessagesYou may also see the following messages on the PrintersScreen.
These Counterfeit or Used messages will come up for each color.Just press OK and the printer will accept the cartridge.
This message is a scare tactic, andcomes up occasionally. Just pressOK to continue.
This message may appear for acartridge from this printer that hasbeen refilled. Just press OK tocontinue. The Leap Frog methodmay need to be used.
-
7/24/2019 HP Refill_932.933.950.951_IS-5000SK-V2.4
6/6
Refill InstructionsHP 932/933/950/951 Cartridges Revised: 02/02/2015
HP Refill_932.933.950.951_IS-5000SK-V2.4 Page 6of 6 Data is subject to change withoutnotice
Chip Installation Instructions
If you purchased the replacement chips for any of the HP 932, 933, 950, or 951 cartridges theseinstructions will provide you with proper installation for those chips. Caution:Please follow all necessaryESD procedures when handling the replacement chips. You can find ESD procedures on the internet.
1. Identify the correct chip has been selected and proceed to remove from the packaging.
2. Carefully remove the white backing off the chip using a flat X-ACTO blade, or similar tool,exposing the adhesive underneath.
3. Once the adhesive is exposed, proceed to carefully place the chip over the existing OEM as
shown. The flat X-ACTO blade works well for this.
4. Once the chip has been placed, press down on the chip gently to secure the adhesive in place.
5. Inspect the chip for proper location as shown.