hyundai i-sheet santa fe nxc aft

INSTALLATION INSTRUCTIONS

Accessory Description

Year / ModelDZ 16280NXc Running Board

2010 Hyundai Sante Fe

Quantity Part Number English Description

2 Various Boards

1 B 2040LP Left Front Bracket

1 B 2041LP Left Middle Bracket

1 B 2042LP Left Rear Bracket

1 B 2040RP Right Front Bracket

1 B 2041RP Right Middle Bracket

1 B 2042RP Right Rear Bracket

10 PN 525 M8 x 25mm Flange Bolt

Bill of Materials:

01.31.122

01.17.11

10 PN 835 Double Weld Tab Plate

2 PN 108 M6 x 25mm Bolt

12 PN 524 M8 x 25mm Square Head Bolt

Read and understand these instructions BEFORE attempting to install this product.





Getting Started.

Begin installation on left side of vehicle by observing the front, and rear bracket locations.

Front Left Bracket Location

Remove rubber plugs from both hole locations.

1

2

01.31.123

01.17.11

Middle Left Bracket Location

Remove rubber plug from hole location (3). location (4) will have a preset insert

.

3

4





Rear Left Bracket Location

Remove rubber plug from both hole locations (5) and (6).

5

6

2

01.31.124

01.17.11

Front Left Bracket

Identify the Front Left Bracket and place M8 x 25mm Flange Bolt and secure with Double Weld Tab

Plate in the front hole (1) of Left Front bracket, and M8 x 25mm Flange Bolt and secure with Double

Weld Tab Plate in the rear hole (2).

1





3

4

7

Middle Left Bracket

Identify the Middle Left Bracket and place M8 x 25mm Flange Bolt and secure with Double Weld Tab

Plate in the front hole (3) of Left Front bracket, and M6 x 25mm Flange Bolt in the rear hole (4) to insert

in vehicle.

01.31.125

01.17.11

Rear Left Bracket

Identify the Rear Left Bracket and place M8 x 25mm Flange Bolt and secure with Double Weld Tab Plate in

the front hole (6) Bracket and place M8 x 25mm Flange Bolt and secure with Double Weld Tab Plate in the

front hole (7) of left rear bracket.

7

6





2

1

Front Left Bracket Location

Place tabs into openings in vehicle and tighten with 13mm wrench for locations (1 and 2).

01.31.126

01.17.11

Middle Left Bracket Location

Insert M6 bolt into bracket and preset in location (4). Place tab into opening in vehicle in the front

location (3) and tighten with 13mm wrench.

4

3





6

7

Rear Left Bracket Location

Insert M8 bolt into bracket and Nutsert in location (4). Place tab into opening in vehicle in the rear

location (3) and tighten with 13mm wrench. Tighten with 13mm wrench.

01.31.127

01.17.11

Install Left Side Step

Place the 8mm square head bolts into the two bolt channels of the running board and slide

toward either end of the board. For this application, there should be two bolts in each

channel on opposite ends of the board.





Place running board onto the brackets. Align 8mm square head bolts in the bottom of the

running board with holes in the brackets. Completely tighten brackets to vehicle. Center

board on vehicle between wheel well openings or until desired appearance is acquired.

Adjust board in/out on vehicle until desired appearance is met. Secure board into place

using 8mm hex nuts.

01.31.128

01.17.11

Right Side.

Repeat above steps for the right side of vehicle to complete.

hyundai i-sheet santa fe nxc aft

Documents