i nsta l l at i on i nst r uc t i ons f or e m e r g e nc ... · 8) installation and servicing...
TRANSCRIPT
I N S T A L L AT I O N I N S T R U C T I O N S F O R E M E R G E N C Y E X I T S I G N
I M P O R T A N T :
When relamping, only use lamps specified in the exit sign. Using other lamp types may result in transformer damage or unsafe conditions.
I M P O R T A N T S A F E G U A R D S When using electrical equipment, basic safety precautions should always be followed, including the following:
R E A D A N D F O L L O W A L L S A F E T Y I N S T R U C T I O N S 1) Do not use outdoors. 2) Do not mount near gas or electric heaters. 3) Equipment should be mounted in locations and at heights where it will not be subject to tampering by unauthorized personnel.
4) The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. 5) Do not use this equipment for other than its intended use. 6) Before wiring to power supply, turn off electricity at fuse or circuit breaker. 7) Consult local building code for approved wiring and installation. 8) Installation and servicing should be performed by qualified personnel.
S AV E T H E S E I N S T R U C T I O N S
I N S T A L L AT I O N I N S T R U C T I O N S
C E I L I N G & E N D M O U N T I N G ( F I G .1) & ( F I G .2) .
1) Connect input as shown in wiring diagram below and fasten canopy to J-box bracket. 2) Snap housing to canopy. 3) Secure faceplate to housing and remove the proper arrow as required.
W ir ing diagr am
(FIG.1)
(FIG.2)
BLACK 120VAC
WA R N I N G :U nused wir es must be capped using enclosed wir e nuts.
LED BOARD
RED 277VAC
WHITE COM T R S
08/11/2010
Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: (954) 442-6600 Fax: (954) 442-6677