imaging unit iu-installation

8/6/2019 Imaging Unit IU-Installation

1/12

Installation

Warning for

Imaging Units(IU's)

It consists of two sections:

A)Things to do before installing Imaging Units.B) Gradation Adjustment

Disclaimer: This document is provided as advice and should not be used as a

substitute for using a certified technician to install imaging units. ARC does not take

responsibility for any damages resulting from the use of this document.


2/12

A)THINGS TO DO BEFORE INSTALLING IMAGING UNITS.After receiving the imaging unit please follow the installation instruction booklets

inside each unit, and additional instructions from ARC Technical Department.

STEP 1

Hold the Imaging Unit as shown in the picture. Then shake the Unit left to right and

right to left 20 times to loosen the developer inside the Unit.

STEP 2

Install the Unit Carefully


3/12

STEP 3

Make sure the Unit is securely installed of the machine

STEP 4

Run the gradation adjustment through the technical representative mode. Please

see for details the section B, Gradation Adjustment Instruction.


4/12

INSTRUCTION B: HOW TO DO THE GRADATION ADJUSTMENT

For most of the color copier models, you have to run "gradation adjustment".

If you do not do the gradation adjustment, it will substantially reduce yields of

Imaging Units.

STEP 1

Insert paper in a tray. Make sure the paper position is portrait.


5/12

STEP 2

Press Utility button

STEP 3

You will see the following display. Hit the Admin. Mode on the touch screen


6/12


7/12

STEP 6

Then you will see the following screen: Press STABILIZER

STEP 7

Once you pressed Stabilizer, you will see the following screen. Press RESET and

STABILIZE


8/12

STEP 8

Press START button

STEP 9

Go to the Admin. Mode and enter the password, you will see this screen again.

This time you hit the GradationAdjustment on the touch screen.


9/12

Then the following display will appear.

STEP 10

Press START Button


10/12

STEP 11

Copier will print out the gradation adjustment result as shown on the picture.

STEP 12

Place the printout on copier to Scan. Make sure that two black spots are positioned

to your left hand side as shown on the picture below.


11/12

When youre done with carefully placing the printout on top of the glass. Close the

top of the copier/scanner, be ready to do Scan.


12/12

STEP 13

Press Start button to Scan the printout page.

If you see the following picture on the LCD display, the procedure completed

successfully. If you get an error message, make sure the printout position (those two

black spots are must be positioned to the left hand side) and repeat the procedure

one more time. After this, if you still get an error message, please give us a call.

imaging unit iu-installation

Documents