installation instructionbroadfeet.com/manuals/dcsm-840-32.pdf2015-2017 smart fortwo . broadfeet...
TRANSCRIPT
BroadfeetMotorsportEquipment WWW.BROADFEET.COM InstallationInstruction
PartIdentificationNumber:DCSM-840-32MountingBracketToVehicleHardware:
Quantity Hardware Quantity Hardware 2 Mounting Bracket 2 Factory Bolt (Not Included)
Can be found on vehicle’s chassis frame.
Mounting Bumper Guard To Mounting Bracket Hardware: Quantity Hardware Quantity Hardware
1 A-Bar Bumper Guard 4 Bolt 4 Nuts 8 Washer 4 Spring Washer
Note:
• Professional installation is highly recommended • Review and understand the installation hardware and procedure before beginning • Periodically check the tightness and alignment of the parts for proper adjustment after completion
Diagram 1.A: Refer to the diagram below when fastening nut to bolt. For fastening procedures that does not require a bracket or bumper, remember the concept demonstrated. The spring should be in between the washer and nut.
Installation Instruction
2015-2017 Smart Fortwo
BroadfeetMotorsportEquipment WWW.BROADFEET.COM InstallationInstruction
Note: Do NOT tighten the nuts until all the parts are fastened and adjusted. Step 1: Fasten the passenger side mounting bracket. The bolt to mount the bracket can be found on the vehicle’s chassis frame. If necessary, remove the plastic skid shield to avoid interference during the installation procedure. Passenger Side Shown:
Trimtheplasticskid(shownwiththeyellowmarking)withahotblade.ForadditionalreferencerefertotheimagesshowninStep3.
BroadfeetMotorsportEquipment WWW.BROADFEET.COM InstallationInstruction
Step 2: Repeat the same mounting procedure on the driver side. Driver side shown: Step 3: Once the brackets are fastened, mount the bumper guard following Diagram 1.A. The bumper guard can either be mounted on the inner or outer side of the mounting bracket. In the images below, the bumper guard was mounted towards the outer side of the mounting bracket. Passenger Side Shown:
BroadfeetMotorsportEquipment WWW.BROADFEET.COM InstallationInstruction
Driver Side Shown: Step 4: Level and adjust the bumper guard, then complete the installation by tightening all the nuts into place.