SlideDriver with Snow Brush and Scraper Kits installed

www.hysecurity.com Page 1 of 2 P/N MX001223, MX001224, MX001229, MX001782 © 2009 D0305 Rev. A

Installation Instructions MX001223, MX001224, MX001229, MX001782

Snow brushes (rail not shown)

Snow scraper

SlideDriver™— Optional Snow Kits

Installing the Snow Brushes

Loosen two screws to remove cover.

Power toggle switch

Control Box

3

1

2

Remove cover and set it aside.

4 Place the aluminum flange on the inside of the chassis and slide snowbrushes into place.

www.hysecurity.com Page 2 of 2 P/N MX001223, MX001224, MX001229 © 2009 D0301 Rev. A

CORRECT installation of snowbrushes Install the snow brushes so the aluminum flange is inside the chassis. Use the supplied washers and nuts to secure the fasteners.

5

Install the Snow Scrapers

Preventing Ice Buildup

VF2/VF3—Prevent ice buildup Cut about 4-inches (10cm) off the lower brushes to prevent ice build-up on the outside limit switches. Pack the switch arms with silicone grease.

CAUTION:

Be aware of the

pinch points

when replacing

the front cover.

Insert the bolts from the outside and secure each one inside the chassis with the supplied washer and nut.