instbws1 - addendum...machine screws place bottom pivot in channel screws pass through assembly...
TRANSCRIPT
Weatherfold 4s 50 & 100INSTBWS1 ADDENDUM REV B - APR 2016
Note: The following steps have been amended for the replacement of a new adjustable top pivot for BWS1-100.
BWS1-100H
Page 3
H type hinge shown
BODYHORIZONTALLYADJUSTS
LOCKINGSCREW
ADJUSTMENTCAM
BUTTON TO RELEASEBOLT TO VERTICALLYADJUST
Adjustable top pivot features
Adjustable top pivot and cover
OPTION A - Allows access to hangers through notch in track OPTION B - Allows access tohangers by removing track section
Track Preparation width)track and chanel cut to length ‘W’ (finished opening
Brio AustraliaP: +61 2 87186718W: E: [email protected]
brio.com.au
Brio UK P: +44 191 2291224W: E:
Brio USA P: +1 585 3195599W: E:
CUT TRACK56[2.21]
40[1.58] 56[2.21]
Use cover as a jig and align to edge of thetrack to drill 2 x Ø5.0[0.2] holes
40[1.58]
2 x Ø5[0.2]
COVER
ALIGN
COVER
PIVOT
MACHINE SCREWS
With the panels closed, loosen toppivot locking screw and adjust tocentralise door panels. Then lockoff top pivot and mark the positionof the bottom pivot
= =
PA
NEL
JA
MB
JA
MB
Mark theposition of the bottom pivot
MARK
Installing Hardware and Hanging Panels clean down inside of track and channelJA
MB
Viewed from outside, insert rollers through access notch in correct order
JAM
B
Fix top pivot into position withmachine screws supplied
JAM
B
MACHINESCREWS
Place bottom pivot in channel
Screws pass through assembly
SILL or CHANNEL14[0.55]
JAM
B
PIVOT BODY
Loosen locking screw and adjusttop pivot so that hinge is touchingthe jamb Lock off when in position.
JAM
B
HINGETOUCHINGJAMB
PA
NEL
ADJUST
Adjustment hinge pin locking mechanism applied to all hangers and top pivot
Open the panels and adjust the bottom pivot to the mark. Thentighten locking screws
CHANNEL
PANEL
PANELPANEL
JAM
B
ALIGNTOMARK
Adjust all hangers and top pivot until panels are parallel with 7mmgap between the track
7[0.28]
Page 8
Page 9
Loosen locking screws and adjustbottom pivot so that hinge is touching the jamb. Lock off when in position.
ADJUST
LOCKINGSCREWS
JAM
B
HINGETOUCHINGJAMB
TRACK
PANEL
PANEL
To adjust height, depress buttonand wind bolt. Bolt locks offautomatically on flats.
depressbutton
Close doors & fix cover into pivot to cover notch.
Now that the doors are in place, open doors and loosen locking screws.
Viewed frominside
CHANNEL JAMB
JA
MB TRACK
COVER