intelilite amf20-25
TRANSCRIPT
LEADER IN GEN-SET
COMMUNICATION SOLUTIONS
DescriptionInteliLite ® AMF 20 and InteliLite ®
AMF 25 are new integrated
controllers for gen-sets operating
in single standby mode. They meet
all possible requirements for AMF
applications, including modem control,
user configuration and full gen-set
monitoring and protection.
InteliLite ® controllers are equipped with
a powerful graphic display. Icons,
symbols and bar graphs for intuitive
operation together with high functionality
set new standards in gen-set control.
Special low temperature (IL-AMF 20-LT
or IL-AMF 25-LT) version is also
available, allowing the display to work
up to -300C.
Benefitsn Less wiring and components
n Integrated solution
n Less engineering and programming
n Perfect price/performance ratio
Featuresn Support of engines equipped
with Electronic Control Unit (J1939
interface)
n Automatic or manual start/stop of the
gen-set
n Push buttons for simple control, lamp
test
n Graphic back-lit LCD display
128x64 pixels
n 6 LED indicators
n Parameters adjustable via keyboard
or PC
n Mains measurements (50/60 Hz):
U1-U3, Hz
n Generator measurements (50/60 Hz):
U1-U3, I1-I3, Hz, kW, kVAr, kWh
n Selectable protections alarm/
shutdown
n 3 phase Generator protections
- Over-/under voltage
- Over-/under frequency
- Current/voltage asymmetry
- Overcurrent/overload
n 3 phase AMF function
- Over-/under frequency
- Over-/under voltage
- Voltage asymmetry
n Analog oil pressure, water
temperature, fuel level, battery
voltage, engine speed (pick-up)
n Configurable programmable inputs
and outputs
n Warm-up and cooling functions
n Generator C.B. and Mains C.B.
control with feedback and return
timer
n RS232 interface (AT-LINK CONV
cable is necessary for IL-AMF 20)
n Modem communication support
(IL-AMF 25 only)
n Dimensions 180x120 mm (front panel)
n Sealed to IP65
InteliLite®
AMF 20/AMF 25Automatic Mains Failure Controller
Manufacturer:
ComAp, spol. s r.o.
Czech Republic
Phone: +420 266 790 611
Fax: +420 266 316 647
E-mail: [email protected]
Internet: www.comap.cz
Local Distributor
Features and specification are subject to change without prior notice. 2004-02
The Chart of Functions of InteliLite® Controllers
InteliLite® AMF 20/AMF 25
7 BINARY INPUTS 5 BINARY OUTPUTS
(OPEN COLLECTOR)
CAN - J1939I/O EXTENSION
(IL-AMF 25 ONLY)
J1939
MAINSGENERATOR
MEASUREMENT
G E N E R A T O R C
. B .
C O N T R O L
M A I N S C
. B .
C O N T R O L
LOAD
MAINS
GENERATOR
IL-AMF 20/25
MEASUREMENTVOLTAGE
ENGINECONTROL
UNIT
3ph 3ph
CURRENT VOLTAGE
S T A R T E R
F U E L S O L E N O I D
A U X
. A L T E R N A T O R
P R E E X C I T A T I O N
RELAYOUTPUTS
ENGINE
D+
O I L P R E S S U R E
W A T E R T E M P
R P M
ANALOGINPUTS
F U E L L E V E L
DIESEL/GAS ENGINE
PC MODEM
POWER SUPPLY8 to 36 VDC
+
RS-232CINTERFACE (IL-AMF 25 ONLY)
+ 24V
A L A R M
I-RD
3ph
IGL-RA15
IG-IOM/IGS-PTM
C H A R G E R F A I L U R E
B I N A R Y O U T P U T S
3 3
E M E R G E N C Y S T O P
G E N E R A T O R C
. B .
F E E D B A C K
M A I N S C
. B .
F E E D B A C K
Automatic Mains Failure Controller
FUNCTIONS/CONTROLLERS IL-AMF 20 IL-AMF 25 IL-MRS 10 IL-MRS 15 IL-MRS 11 IL-MRS 16
Binary inputs/outputs 7 / 7 7 / 7 6 / 6 6 / 6 6 / 6 6 / 6
Analog inputs 3 3 3 3 3 3
Pick-up • • • • • •AMF function • • - - - -
Input configuration • • • • • •Output configuration • • • • • •Voltage measurement Gen./Mains 3ph / 3ph 3ph / 3ph 3ph / - 3ph / - 3ph / - 3ph / -
Current measurement 3ph 3ph, IDMT overcurrent 3ph 3ph, IDMT overcurrent 3ph 3ph, IDMT overcurrent
kW/kWh measurement • / - • / • • / - • / • • / - • / •GCB/MCB control with feedback • / • • / • - / - - / - •1) / - • / -
Extension units(periph.)
- IGL-RA15, IG-IOM,IGS-PTM
- IGL-RA15, IG-IOM,IGS-PTM
- IGL-RA15, IG-IOM,IGS-PTM
Communication interfaces RS232 2) RS232, CAN3) RS2322) RS232, CAN3) RS2322) RS232, CAN3)
Modem support - • - • - •Battery charging alternator circuit • • • • • •
Key: • included; - excluded 1) GCB control, but without feedback 2) AT-LINK CONV cable necessary 3) CAN for periph.
Legend: IG-IOM/IGS-PTM: I/O extension modules IGL-RA15: Remote annunciator I-RD: Remote display