introducing verve iv - focal point lights · verve iv is a natural progression of the verve family...
TRANSCRIPT
Verve IVintroducing
Verve IVVerve IV is a natural progression of the Verve family of linear luminaires. Practical and budget friendly, this new design aptly addresses the evolving needs of designers to illuminate spaces using less energy. A new collection of shielding choices, coupled with lamping flexibility and high efficiencies provides a superior lighting solution and great aesthetics in any environment.
Get more with Verve IV.
Verve Family Verve I Unobtrusive and sleek indirect. Verve I has a low-profile look that blends with architecture.
Verve II Versatile indirect with perforation and a wide array of lamping configurations in a budget-conscious design.
Verve IIIHigh Performance Direct/Indirect. Our low-brightness parabolic louver adds a controlled direct component to boost footcandle levels while maintaining visual comfort and high efficiency.
Verve IV
9.0"229 mm
3.8"96.5 mm
2.5"
64.5
mm
Shielding More Appeal
Six different shielding options make Verve IV one of our most aestheticallyversatile luminaires. Choose from a traditional Radial or Flat Blade Baffle, Parabolic Louver, or one of three different lens options. Specify the Acrylic Overlay to hide lamps from view on louver and baffle options.
Standard with lens shielding, the debris shield, seen below in orange, forces dust, dirt and debris to the sides minimizing their visual impact on the lens itself.
Frosted Acrylic Lens
Semi-Specular Flat Blade Parabolic Louver
Flat Blade Radial Blade Acrylic Lens
Round Patterned Acrylic Lens
Flat Blade Baffle
Square Patterned Acrylic Lens
Radial Blade Baffle
Open Optic** (Standard)
DR0 (100% downlight)
DR1 (up to 85% downlight)
DR2 (up to 80% downlight)
DR4 (up to 60% downlight)
Verve IV’s optional DR optics deliver light where you need it. Increased direct illumination suits ceiling heights from low to high, providing an opportunity to reduce lamps while maintaining light levels. Limited indirect illumination creates a soft glow on the ceiling to minimize contrast and cave effect.*
More Downlight
Performance
*actual percentages vary depending on lamping and shielding. For accurate percentages refer to IES test data available at www.focalpointlights.com.**4’, Radial Baffle, 2-T5 lamping.
More Balanced
Verve IV’s indirect/direct distribution contributes the type of performance needed to meet light level and energy recommendations, balanced with shielding options that provide glare control and visual interest. Choose the louver or baffle for 40% downlight and classic styling, or a lensed version for modern looks and more uplight. Radial Blade Baffle
2-lamp T5 99% efficiency
60%40%
Frosted Acrylic Lens 2-lamp T5
96.5% efficiency
75%25%
Value Added Options
More Energy Conscious
Integrated daylight sensors not only help meet new stricter code requirements, but keep ceilings clean and eliminate sensor interference from indirect light produced by the luminaire. Daylight and occupancy sensors are standard catalog options.* *Additional sensors may be available to meet your needs.
More Maintainable
Select the clear acrylic dust cover for environments where quick and easy cleaning is desired. This option provides a smooth surface for wiping off dust and debris.
More Control
Available on all 3-lamp configurations, the downlight reflector optic (PDR), isolates the center lamp for direct distribution and two outer lamps for indirect distribution. Independent switching of direct and indirect light sources makes Verve IV with the PDR optic ideal for both standard and AV teaching modes in classrooms.
All standard configurations meet or exceed our everGreen™ standard of 80% or more efficiency.
Design Guides
30'x30' | 10' Spacing
Radial Baffle Frosted Lens Radial Baffle Frosted Lens
10' Ceiling | 24" Suspension 8.5' Ceiling | 18" Suspension
1T5HO 45.4 3:1 6:1 42.3 2:1 7:1 44.9 3:1 8:1 44.8 3:1 8:1
2T8 53.0 3:1 6:1 49.7 3:1 7:1 55.9 3:1 7:1 52.5 3:1 8:1
2T5 56.2 3:1 6:1 50.6 3:1 7:1 59.3 3:1 7:1 53.5 3:1 8:1
2T5-DR2 48.0 3:1 4:1 33.0 3:1 5:1 50.1 4:1 4:1 34.8 3:1 6:1
30'x30' | 14' Spacing
Radial Baffle Frosted Lens Radial Baffle Frosted Lens
10' Ceiling | 24" Suspension 8.5' Ceiling | 18" Suspension
1T5HO 32.2 3:1 7:1 29.7 3:1 8:1 33.8 4:1 8:1 31.3 3:1 10:1
2T8 37.6 3:1 7:1 35.0 3:1 8:1 39.3 4:1 8:1 36.8 3:1 9:1
2T5 39.8 3:1 7:1 35.6 3:1 8:1 41.7 4:1 8:1 37.5 3:1 10:1
2T5-DR2 34.7 4:1 4:1 23.9 3:1 6:1 36.0 5:1 5:1 25 4:1 7:1
Download additional guides at www.focalpointlights.com.
Reflectances: 80/50/20
Light Loss Factors: T8 - 0.75 T5/T5HO - 0.85
Light levels calculated in AGI-32. Calculations do not include any furniture or partitions.
Average Footcandles
Workplane Uniformity
Ceiling Uniformity
baffle/louverfixture series FV4S
Verve IV FV4S
shieldingRadial Blade Baffle - White RB
Flat Blade Baffle - White FB
Semi-Specular, Flat Blade Parabolic Louver PL
shielding accessoriesDownlight Reflector - isolates center lamp PDR
(3-lamp & dual circuit options only)
100% downlight DR0Up to 85% downlight DR1
Up to 80% downlight DR2Up to 60% downlight DR4
lamping2 Lamp T5 2T53 Lamp T5 3T5
1 Lamp T5HO 1T5HO2 Lamp T5HO 2T5HO3 Lamp T5HO 3T5HO
2 Lamp T8 2T83 Lamp T8 3T8
circuitSingle Circuit 1C
Dual Circuit 2C(Multiple lamp luminaires only)
voltage120 Volt 120277 Volt 277347 Volt 347
ballastElectronic Instant Start <20% THD E
(T8 Only)Electronic Program Start <10% THD S
Electronic Dimming Ballast D
mounting24" Cable Suspension C2448" Cable Suspension C4896" Cable Suspension C96
(Specify “J" in place of “C" for 5" dia. canopies at power feed and 2" dia.
canopies at non–feed locations)(Consult factory for sloped ceiling applications)
factory optionsAcrylic Overlay on Louver or Baffle AO
(T5, T5HO only. May not be combined with DC)
Dust Cover DC(May not be combined with AO)
Emergency Circuit ECEmergency Battery Pack EM
HLR/GLR Fuse FUInclude 3000K Lamp L830Include 3500K Lamp L835Include 4100K Lamp L841
Lutron™ Daylight Sensor LY1(EcoSystem ballast required)
Lutron™ Sensor Feed SF(EcoSystem ballast required)
Philips® Daylight Sensor PY1(0–10V dimming ballast required)
WattStopper™ Daylight Sensor WY1(0–10V dimming ballast required)
WattStopper™ Occupancy Sensor WO1
finishMatte Satin White WH
Titanium Silver TS
luminaire length4' 4'8' 8'
12' 12'16' (8'+8') 16'
20’ (12’+8’) 20'24' (12'+12') 24'
integrator options90-degree Corner FV4–90
remotes(specify quantity)
WattStopper™ Daylight Setup Remote WYSR(required for daylight programming,
one included per order)
WattStopper™ Occupant Controller WOR
lensfixture series FV4S
Verve IV FV4S
shieldingFrosted Acrylic Diffuser AC
Round Patterned Diffuser RASquare Patterned Diffuser SA
shielding accessoriesDownlight Reflector - isolates center lamp PDR
(3-lamp & dual circuit options only)
100% downlight DR0Up to 75% downlight DR1
Up to 60% downlight DR2Up to 50% downlight DR4
lamping2 Lamp T5 2T53 Lamp T5 3T5
1 Lamp T5HO 1T5HO2 Lamp T5HO 2T5HO3 Lamp T5HO 3T5HO
2 Lamp T8 2T83 Lamp T8 3T8
circuitSingle Circuit 1C
Dual Circuit 2C(Multiple lamp luminaires only)
voltage120 Volt 120277 Volt 277347 Volt 347
ballastElectronic Instant Start <20% THD E
(T8 Only)Electronic Program Start <10% THD S
Electronic Dimming Ballast D
mounting24" Cable Suspension C2448" Cable Suspension C4896" Cable Suspension C96
(Specify “J" in place of “C" for 5" dia. canopies at power feed and 2" dia.
canopies at non–feed locations)(Consult factory for sloped ceiling applications)
factory optionsDust Cover DC
Emergency Circuit ECEmergency Battery Pack EM
HLR/GLR Fuse FUInclude 3000K Lamp L830Include 3500K Lamp L835Include 4100K Lamp L841
Lutron™ Daylight Sensor LY1(EcoSystem ballast required)
Lutron™ Sensor Feed SF(EcoSystem ballast required)
Philips® Daylight Sensor PY1(0–10V dimming ballast required)
WattStopper™ Daylight Sensor WY1(0–10V dimming ballast required)
WattStopper™ Occupancy Sensor WO1
finishMatte Satin White WH
Titanium Silver TS
luminaire length4' 4'8' 8'
12' 12'16' (8'+8') 16'
20’ (12’+8’) 20'24' (12'+12') 24'
integrator options90-degree Corner FV4–90
remotes(specify quantity)
WattStopper™ Daylight Setup Remote WYSR(required for daylight programming,
one included per order)
WattStopper™ Occupant Controller WOR
Close-to-Ceiling Performance
30'x30' | 14' SpacingRadial Baffle
8’ Ceiling | 6” Suspension
2T5-DR1 35.1 5:1 4:1
2T5-DR2 35.7 5:1 5:1
8’ Ceiling | 12” Suspension
2T5-DR1 36.1 6:1 4:1
2T5-DR2 36.0 5:1 5:1
Even when mounted 6” from the ceiling, Verve IV with a DR optic produces superior ceiling uniformity and the right amount of light for most office and educational applications.
©2010 Focal Point LLC, 4141 S. Pulaski Road, Chicago, Illinois 60632, www.focalpointlights.com, T 773.247.9494, F 773.247.8484All rights reserved. “Focal Point”, “The Art of Light”, everGreen, Verve and the Light-Ray Graphic are trademarks or registered trademarks of Focal Point, LLC. Products shown in this brochure may be covered by U.S. patents and patents pending.
Visit focalpointlights.com for specifications and other details on our entire Focal Point catalog. 01/10 #MKT1086