introductory chemistry: a foundation fifth edition by ms. goldamer greenfield high school
DESCRIPTION
Introductory Chemistry: A Foundation FIFTH EDITION by Ms. Goldamer Greenfield High School. Nomenclature Chapter 5. CHEMISTRY 100 Dr. Jimmy Hwang Sections 5 and 7 Tu & Th 9:30a.m.-10:45a.m. Textbook: Zumdahl, Introductory Chemistry, 5 th Edition Office Hours: by appointment - PowerPoint PPT PresentationTRANSCRIPT
1
Introductory Chemistry: A Foundation
FIFTH EDITION
by Ms. GoldamerGreenfield High School
2
Nomenclature
Chapter 5
3
CHEMISTRY 100Dr. Jimmy HwangSections 5 and 7
Tu & Th 9:30a.m.-10:45a.m.
Textbook: Zumdahl, Introductory Chemistry, 5th Edition
Office Hours: by appointment
619-421-6700 Ext. 3399 (voicemail)
Email: [email protected]
4
OverviewIn Chapter 5, our goals are for the students to:
1. Learn how to name binary compounds of a metal and a nonmetal.2. Learn how to name binary compounds containing only nonmetals.3. Learn the names of common polyatomic ions and how to use
them in naming compounds. 4. Learn how the anion composition determines the acid’s name.5. Learn names of common acids.6. Learn to write the formula of a compound given its name.
5
Common Names - Exceptions
• H2O = water, steam, ice
• NH3 = ammonia
• CH4 = methane
• NaCl = table salt
• C12H22O11 = table sugar
6
Naming Starts with Classifying Compounds
• Binary Compounds = only 2 elements
• Compounds containing polyatomic ions
• Acids = formula often starts with H
7
Classifying Binary Compounds
• Compounds containing a metal and a nonmetal are binary ionic– Type I and II
• Compounds containing two nonmetals– Type III
• Compounds containing H and a nonmetal = Acids
8
Binary Ionic
• Made of metal cation and nonmetal anion
• Name by naming the ions
9
Metal Cations• Type I
– Metals that can only have one possible charge– Determine charge by position on the Periodic
Table
• Type II– Metals that can have more than one possible
charge– Determine metal cation’s charge from the
charge on anion
10
Type I Binary Ionic Compounds
• Contain Metal Cation + Nonmetal Anion
• Metal listed first in formula & name
¶ Name metal cation first, name nonmetal anion second
¶ Simple metal cation name is the metal name– simple metals are Groups 1A, 2A and Al, Ga & In
¶ Nonmetal anion named by changing the ending on the nonmetal name to -ide
11
Naming CompoundsNaming Compounds
1. Cation first, then anion
2. Monatomic cation = name of the element
Ca2+ = calcium ion
3. Monatomic anion = root + -ide
Cl = chloride
CaCl2 = calcium chloride
Binary Ionic Compounds (Type I):Binary Ionic Compounds (Type I):
12
Memorize Table 5.1
13
Principle of Electrical Neutrality
• The principle that, in any ionic compound, the total positive charge must equal the total negative charge, i.e., a chemical compound must have a net charge of zero.
14
Determining the Charge on a Cation – Au2S3
using the Principle of Electrical Neutrality Determine the charge on the anion
Au2S3 - the anion is S, since it is in Group 6A, its charge is -2 Determine the total negative charge
since there are 3 S in the formula, the total negative charge is -6
Determine the total positive chargesince the total negative charge is -6, the total positive charge is +6
Divide by the number of cationssince there are 2 Au in the formula & the total positive charge is +6, each Au has a +3 charge
15
Type II Binary Ionic Compounds• Contain Metal Cation + Nonmetal Anion• Metal listed first in formula & name
¶ Name metal cation first, name nonmetal anion second¶ Metal cation name is the metal name followed by a
Roman Numeral in parentheses to indicate its charge– Determine charge from anion charge
– Common Type II cations in Table 5.2
¶ Nonmetal anion named by changing the ending on the nonmetal name to -ide
16
Figure 2.22: The common cations and anions
17
Monatomic Ions
• 2. Transition metal cations (Figure 2.22)• Memorize the charge of other metals in Figure 2.8. It
is easy to remember the charges of the metal ions in the figures as follows:
• +1: all alkali metals, Ag+, Cu+, Hg22+
• +3: Al3+, Co3+, Cr3+, Fe3+, Mn3+ (AC2FM)• +4: Sn4+ , Pb4+
• +2: everything else• Note that some metals have two charges (Type II).
18
FeCl2 2 Cl- -2 so Fe is +2 iron(II) chloride
FeCl3 3 Cl- -3 so Fe is +3 iron(III) chloride
Cr2S3 3 S2- -6 so Cr is +3 (6/2) chromium(III) sulfide
Principle of Electrical NeutralityThe principle that, in any ionic compound, the total positive charge must equal the total negative charge, i.e. a chemical compound must have a net charge of zero.
19
20
Naming Compounds(continued)
Naming Compounds(continued)
metal forms more than one cation
use Roman numeral in name
PbCl2
Pb2+ is cation
PbCl2 = lead (II) chloride
Binary Ionic Compounds (Type II):Binary Ionic Compounds (Type II):
21
22
QUESTIONWhat is the formula for manganese(IV) oxide? 1) MgO2 2) Mn4O 3) MnO2 4) Mn2O 5) Mg2O
23
ANSWER3) MnO2 Section 5.7 Writing Formulas from Names (p. 142) Oxide ion always carries a –2 charge; as the Roman numeral indicates a +4 charge for manganese, there must be two oxides for each manganese cation for electrical neutrality.
24
Type III - Binary Compounds of 2 Nonmetals
• Name first element in formula first, use the full name of the element
• Name the second element in the formula as if it were an anion– However, remember these compounds do not contain ions!
• Use a prefix in front of each name to indicate the number of atoms
• Never use the prefix mono- on the first element
25
Prefixes
• Drop last “a” in the prefix if the name begins with vowel
octa-8
hepta-7
hexa-6
penta-5
tetra-4
tri-3
di-2
mono-
(not used on first nonmetal)
1
PrefixSubscript
26
NF3 nitrogen trifluoride
SO2 sulfur dioxide
N2Cl4 dinitrogen tetrachloride
NO2 nitrogen dioxide
N2O dinitrogen monoxide
Molecular Compounds
2.7
TOXIC!
Laughing Gas
27
Figure 5.1: A flow chart for naming binary compounds.
28
QUESTIONWhat is the formula for sulfur hexafluoride? 1) S3F 2) SF4 3) S6F 4) SF5 5) SF6
29
ANSWER5) SF6 Section 5.3 Naming Binary Compounds That Contain Only Nonmetals (Type III) (p. 132) The Greek prefix hexa- indicates six of the fluoride anions are present in this Type III compound. As sulfur contains one prefix, we know there is only one sulfur atom present, and the formula of sulfur hexafluoride must be SF6.
30
Compounds Containing Polyatomic Ions
• Polyatomic ions are charged entities that contain more than one atom– Must memorize name, formula and charge– Look for Patterns!!
• Polyatomic compounds contain one or more polyatomic ions
• Name polyatomic compounds by naming cation and anion– Non-polyatomic ions named like Type I and II
• Polyatomic Acids contain H+ and a polyatomic anion
31
Patterns for Polyatomic Ions
Elements in the same column on the Periodic Table form similar polyatomic ions– same number of O’s and same charge
ClO3- = chlorate BrO3
- = bromate If the polyatomic ion starts with H, add
hydrogen- before the ions name and add 1 to the charge
CO32- = carbonate HCO3
- = hydrogen carbonate
32
Patterns for Polyatomic Ions
• -ate ion– chlorate = ClO3
-
• -ate ion plus 1 O same charge, per- prefix– perchlorate = ClO4
-
• -ate ion minus 1 O same charge, -ite suffix– chlorite = ClO2
-
• -ate ion minus 2 O same charge, hypo- prefix, -ite suffix– hypochlorite = ClO-
33
34
Figure 5.2: Overall strategy for naming
chemical compounds.
35
Acids
• Contain H+ cation and anion
• Binary acids have H+ cation and a nonmetal anion
• Oxyacids have H+ cation and a polyatomic anion
36
Memorize
37
Memorize
38
Figure 5.3: A flow chart for naming acids. The acid is considered as one or
more H+ ions attached to an anion.
39
Memorize
• Acid Anion Name
• HClO4 perchlorate perchloric acid
• HClO3 chlorate chloric acid
• HClO2 chlorite chlorous acid
• HClO hypochlorite hypochlorous acid
40
QUESTIONWhat is the formula for copper(I) chloride? 1) CuCl2 2) CuCl 3) CuClO 4) CuClO2 5) CuClO3
41
ANSWER2) CuCl Section 5.7 Writing Formulas from Names (p. 142) Since it is known that chloride is always –1, the designation of copper as a +1 ion means this complex must exist with copper and chloride in a 1:1 ratio.
42
QUESTIONWhich of the following is named correctly? 1) HCl(aq); hypochlorous acid 2) (NH4)3PO3; ammonium phosphate 3) H2SO3(aq); sulfuric acid 4) Cu(OH)2; copper(II) hydroxide 5) HNO3(aq); nitrous acid
43
ANSWER4) Cu(OH)2; copper(II) hydroxide Section 5.7 Writing Formulas from Names (p. 142)
44
Writing the Formulas from the Names
• For Type III compounds, use the prefixes to determine the subscripts
• For Type I, Type II, polyatomic Compounds and Acids– Determine the ions present– Determine the charges on the cation and anion– Balance the charges to get the subscripts
45
Naming Exercise• Al2(C2O4)3
• P4O10
• Cu(NO2)2
• NaMnO4
• CS2
• Fe2(CrO4)3
• Hg2Cl2
• NH4BrO2
• Ca(ClO4)2
• Aluminum oxalate
• Tetraphosphorous decaoxide
• Copper(II) nitrite
• Sodium permanganate
• Carbon disulfide
• Iron(III) chromate
• Mercury(I) chloride
• Ammonium bromite
• Calcium perchlorate