invue security instructions for studio, dial, accessories...
TRANSCRIPT
InVue Security Instructions for Studio, Dial, Accessories, and Surface Book
with Performance Base
List of Parts:
A. (1) C– Clamp Sensor (For Surface Dial) (PN# DNER50W)
B. (1) Custom Keyboard sensor (ZA2714W)
C. (1) Surface Mini Display Sensor and Screen Sensor Cable (DNTZ202W)
D. (1) Zips 2.0 4-Port Alarm Unit (PN# ZA2601-W)
E. (1) Custom Mouse acrylic (sled has no pn#) and sensor (ZA2714W for sensor)
F. Surface Pen Alarming Sensor (PN# ZA2701W)
4. Attach the Surface Book power supply to the
Surface Book.
5. Attach the sensor over the power supply.
Pull the red tabs across the keyboard to adhere
the device, do NOT pull up or down.
6. Two cable clips are includ-
ed for cable management.
Attach the security cable to
the Surface power cable as
shown.
7. Plug sensor into cen-
tral alarm unit. An audi-
ble chirp should be
heard
Surface Book with Performance Base Installation (Continued)
Surface Studio Installation
2. Plug sensor into
central alarm unit.
An audible chirp
should be heard
1. Surface Studio device will only re-
quire one sensor. Please plug the MDP
(Mini Display Port) sensor into the MDP
port on the back of the Surface Studio
Surface Book with Performance Base Installation
2. Slide on the screen sensor with tabs in
place. Sensor placement should be close to
the bottom of the screen. This sensor should
be high enough from the bottom to prevent
interference with the Mini Display sensor
when in draw mode.
3. Ensure to pull red tabs once the
sensor is in place. Pull the tabs direct-
ly across the screen, do not pull down
or up.
1. Wipe all areas where adhesive will
be used on the device with the included
alcohol wipe. This will ensure the ad-
hesive bonds properly for a lasting
installation
Surface Studio Accessories Installation—Dial
1. Install the C-Clamp security compo-
nent on the outside of the Surface Dial as
shown above. Dial should be placed to
the LEFT of the device
2. Plug the C-Clamp sensor into the Zips
4 port hub
Surface Studio Accessories Installation—Mouse, Keyboard, and Pen
1. Remove the protective backing from
the acrylic security piece and adhere to
the bottom of the mouse. Ensure the tab
for the tether is facing the front of the
mouse as pictured
2. Plug the mouse sensor into the Zips 4
port hub
3. Adhere the Mini-Sensor to the bottom
of the keyboard on a flat position. Press
firmly for 30 seconds to ensure proper
adhesion.
4. Plug the keyboard sensor into the Zips
4 port hub
5. Adhere the Surface Pen sensor along a
curved edge of the Surface Pen. Secure a Zip
Tie through the hole on the sensor to allow for a
tight fit
6. Plug the Pen sensor into the Zips 4
port hub
Zips 2.0 4—Port Alarm Installation
1. Note: Once placed down this cannot be moved, ensure this is placed appropriately. Secure Zips 2.0 4—Port
Alarm behind the Surface Studio. Remove the adhesive backings (4) from the bottom of the device and pull the
battery tab to activate. Once placed, the top will rotate 1/2 turn counter-clockwise to expose the Micro USB ports on
both ends, 4 total. When all cables have been plugged in, rotate the top clockwise to close.