Further InformationIf you have any questions then give us Email us on service@tonerider.comor give us a a call on +44 1227 469414 (UK). More wiring guides are available for downloadat www.tonerider.com

PRINTREF: WIR006a

Thanks for purchasing a Tonerider Jazz Bass Pickup. By far the easiest way to a trouble-free installation is to carefully note down where your previous pickup was connected to, and use this a a guide for correct installation on your instrument.

PolarityAll our Jazz Bass series pickups use a reverse-wound neck pickup for noise-cancelling operation. We use the following polarity and winding direction.- Neck: North Pole Up / Counter-Clockwise Wind.- Bridge: South Pole Up / Clockwise Wind

Standard InstallationIn most Jazz Bass instruments the yellow or white “Hot” wire from each pickup is soldered to the middle lug of the potentiometer that will control the pickup’s volume. The “Ground wire” (black) from each pickup is soldered to the back of the corresponding volume potentiometer.

Capacitor and Potentiometer ValuesWe design all our Jazz pickups to perform with the most common industry configurations - 250k Audio Pots and 0.047uf capacitors. Using smaller cap values, such as 0.01uF or 0.022uF, will make it easier to accurately control the amount of treble that is dialled out, but with lower maxi-mum settings.

Tonerider Jazz Bass Wiring