k12 surface mount bollards bol - rsa protect · 2020. 6. 29. · step 3 – pick and drop bollard...
TRANSCRIPT
Bol
Entire K12 Surface Mount Bollard system under 50,000lbs. GVW One truck load
Minimum set required for ASTM M50 P1 (DOS K12)
K12 Surface Mount Bollards 1573 Mimosa Court Upland, Ca 91784
TEL: (909) 946-0964 FAX: (909) 946-1186 [email protected] www.rsaprotect.com
909-946-0964
Page 2
Installation Sequence STEP 1 – PICK and DROP Small End Blocks (2) near bollard line STEP 2 – PICK and DROP Large End Blocks (2) on bollard line STEP 3 – PICK and DROP Bollard Trays (2) (six per tray) near bollard line STEP 4 – PICK and DROP Bollard Boxes (4) on bollard line STEP 5 – Remove locking pins and bollard caps (all 12 bollards) STEP 6 – Insert bollards into sleeves in Bollard Boxes (12) STEP 7 – Drop down small end blocks over Bollard #2 and Bollard #11 STEP 8 – Drop down connection plates between bollard boxes 1-2, 2-3 and 3-4 STEP 9 – Secure all locking pins STEP 10 – Add sand to all Large and Small End Blocks
Page 3
Page 4
Small end block placed over Bollard #2 and Bollard #11
Page 5
Base Box (4) no ballast required Concrete filled Bollard (12) 2” Connection Plate (3) 6,500# ea. 750# ea. 1,900# ea.
Large End Block (2) –ballast required Small End Block (2) ballast required RSA Locking pin (20) 2,100# ea. w/10,000#ballast 1,200# ea. w/3,200#ballast
Hoist (8)
ELEMENTS
Page 6
Four Bollard Boxes (3 bollards/box)
Two Bollard Trays (6 bollards/tray)
Three connection
plates
Large End Block (2)
Small End Block (2)
Locking pins, bollard covers connected to Bollard Boxes
Sand filling siphon Lifting hoist (8)
Page 7
STEP 1 – PICK and DROP Small End Blocks (2) near bollard line
Page 8
STEP 2 – PICK and DROP Large End Blocks (2) on bollard line
Page 9
STEP 3 – PICK and DROP Bollard Trays (2) (six per tray) near bollard line
Page 10
STEP 4 – PICK and DROP Bollard Boxes (4) on bollard line
Page 11
STEP 5 – Remove locking pins and bollard caps (all 12 bollards)
Page 12
STEP 6 – Insert bollards into sleeves in Bollard Boxes (12)
Page 13
STEP 6 – Insert bollards into sleeves in Bollard Boxes (12)
Page 14
STEP 7 – Drop down small end blocks over Bollard #2 and Bollard #11
Page 15
STEP 8 – Drop down connection plates between bollard boxes 1-2, 2-3 and 3-4
Page 16
STEP 9 – Secure all locking pins
Page 17
STEP 10 – Add sand to all Large and Small End Blocks
Page 18
Fully Assembled System
Page 19