knuckle inventor.pdf

AUTODESK INVENTOR FILE CO12106

FORK END

Draw the sketch with given dimension and constraints.

Extrude it for 120 mm.

Select the top surface and draw the sketch

Use extrude and cut the inner piece.


Draw the sketch using two circle and constraining them as tangent

Cut the above portions.

Select the given surface, draw the circle and extrude it for 25mm.


Use fillet tool and round it for 2 mm.

Draw the given sketch on the side view.

Use the revolve command

Revolve for 360 degree and revolve around edge.

Use mirror feature select the feature and corresponding tool

Repeat it twice till the desired product is obtained.


EYE END

Draw the above given sketch with following dimensions.

Select extrude ,and extrude it to 60 mm.


Again draw the given sketch using suitable constraints ,lines and

circles.

Select revolve and revolve around the corresponding edge.

Use mirror feature .

Select the given feature and mirror it around the given axis.

Select the given feature and mirror it around the given plane.


Draw the given sketch on the corresponding surface.

Extrude it for 20mm.

Use fillet feature command ,use it for 2 mm


KNUCKLE PIN

Draw the above sketch, ectrude it for 10mm.

After extrusion again draw the sketch and extrude it for 150 mm.

The extrusion will look like this.


Select the above plane and draw the circle on it.

Select extrusion on it and remove material from it thus creating a

hole in it.


COLLOR

Draw two concentric circles of diameter of 50mm and .

Select extrude and extrude it for 25 mm.

Select plane perpendicular to surface

Draw a circle of dia 3mm.

Select extrude use cut both ways and remove material.


The collor will look like this.


PIN

Draw a circle of diameter 6 mm .

Extrude it for 70 mm.


ASSEMBLY OF KNUCKLE JOINT

Place the fork end using insert component.


Insert the eye end and mate the circular sufaces.

Again mate the axis of both the circular ends.

Then use the angle constraint

Align the axis perpendicular to each other.

.

Insert a new component knuckle pin.

Mate the inner and outer cylindrical surfaces as shown

Then mate the top end of the pin with the protruding end.


Insert the collor using place component.

Mate the axis of hole to the axis of the knuckle pin.

Lastly insert the pin using the axis of collor and knuckle pin.


KNUCKLE JOINT


SUBMITTED TO:

MR. NIPUN SHARMA

knuckle inventor.pdf

Documents