kta19-p600 spec.& scope of supply with gearbox hc400
TRANSCRIPT
-
7/27/2019 KTA19-P600 Spec.& Scope of Supply With Gearbox HC400
1/4
Cummins
TechnicalSpecification
MODELKTA19-P600 Marine Engine(600hp/1800rpm)
-
7/27/2019 KTA19-P600 Spec.& Scope of Supply With Gearbox HC400
2/4
GENERAL ENGINE DATA
ENGINE MODEL: KTA19-P600
RATED POWER600 bhp @ 1800rpmDisplacement: 18.9LAspiration: Turbocharged & after cooled
Bore: 159 mm
Stroke: 159 mm No. of Cylinders: 6 in line
Emission Control: EPA Tier1
FUEL SYSTEMPT PumpEngine Wet Weight (Pricing configuration)2769kg
Center of Gravity from Front Face of Block 572mm
Center of Gravity above Crankshaft Centerline 239mm
ENGINE MOUNTING
Maximum (Static) Bending Moment at Front Support Mounting Surface1356 N.m
Maximum (Static) Bending Moment at Side Pad Mounting Surface 79 kg.m2
EXHAUST SYSTEM
Maximum Back Pressure10 Kpa
Exhaust Pipe Size Normally Acceptable127mm
AIR INTAKE SYSTEM
Maximum Intake Air Restriction with Heavy Duty Air Cleaner
Clean Element..3.74 kPa
Dirty Element..6.23 kPa
Minimum Dirt Holding Capacity with Heavy Duty Air Cleaner53 g/litre/sec.
Maximum Temperature Rise from Ambient to the Inlet of the Turbocharger 17Maximum Pressure Drop from the Turbocharger Outlet to the Intake Manifold14kPa
LUBRICATION SYSTEM
Normal Operating Oil Pressure Range.310~483kPa
Maximum Lube Oil Flow for Engine Accessories.469 litre/min.
Maximum Sump Oil Temperature.121Minimum Engine Oil Pressure for Engine Protection Devices:At Rated Speed and Load 310kPa
At Torque Peak Speed and Load483 kPa
At Low Idle 138kPa
Minimum Required Lube System Capacity - Sump plus Filters. 38.6 litre
By-pass Filtration Required. Yes
Angularity of Standard Oil Pan: (Values stated are for intermittent operation only):
Front Down 30
Front Up30
Side to Side30
-
7/27/2019 KTA19-P600 Spec.& Scope of Supply With Gearbox HC400
3/4
COOLING SYSTEM
Coolant Capacity - Engine Only30 litre
Maximum Engine Cooling Circuit External Resistance35 kPa
Minimum Pump Inlet Pressure with Open Thermostat and no Pressure Cap kPa
Maximum Static Head of Coolant Above Engine Crankshaft Centerline.18.3m
Standard (modulating) Thermostat Range82-93Maximum Block Coolant Pressure with Closed Thermostat and no Pressure Cap241kPa
Minimum Pressure Cap 50kPa
Maximum Engine Coolant Temperature at Engine Outlet93.3Maximum Engine Coolant Temperature for Engine Protection Devices100
Minimum Engine Coolant Temperature71
CRANKING SYSTEM 24V
Minimum Battery Capacity - Cold Soak at 0F (18C) or Above
Engine Only - Cold Cranking Amperes900 CCA
Engine Only - Reserve Capacity320 min
Maximum Starting Circuit Voltage Drop @ ----AmperesTBD
Minimum Ambient Temperature for Unaided Cold Start-12(-F)
Minimum Cranking Speed Required for Unaided Cold Start
Breakaway Torque at Minimum Unaided Start TemperatureTBD
Cranking Torque at Minimum Unaided Start Temperature TBD
Cranking Torque at -10FTBD
FUEL SYSTEM
Maximum Fuel Flow on the Supply Side of the Fuel Pump Litre/hr
Maximum Fuel Inlet Restriction
with clean fuel filter13.3 kPa
with dirty fuel filter. 26.7 kPa
Maximum Fuel Drain Restriction
with check valves22 kPa
less check valves8.5 kPa
Maximum Fuel Inlet Temperature71
Minimum Fuel Tank Air Venting Capability Required at 6 in. H2O Back Pressure425L/H
Low Idle Set Speed650rpmMaximum Overspeed Capability2400rpm
Closed Throttle Torque @ 700 rpm (for 900 rpm Low Idle Speed) TBD
GEARBOX (Transmission)
Model: Advance HC400
Ratio: 3.5:1
Rate (Hp/rpm) 0.45
For engine Speed1000~1800rpm
Dimension 641*890*890mm
Net Weight 800 kgs
-
7/27/2019 KTA19-P600 Spec.& Scope of Supply With Gearbox HC400
4/4
Scope of Supply for
KTA19-P600 With Gearbox
Standard List:
1/ Diesel Engine
Engine Mounting
Flywheel and Flywheel House
Engine alternator and Starter with 24 V D.C.
Fuel Filter, Oil Filter, Coolant Filter
Air Filter Assembly, Air Intake Resistance Indicator, Support and Air Intake Tube. Heat exchanger Raw water pump Engine monitor
Fuel Pre-Filter and Support Engine monitor Literatures: Manual etc.
Tools Kit.
2/ Gearbox
Advance Gearbox HC400 (3.5:1)
3/ Base
Steel Skid base