lathe quiz answer the following questions by left clicking the mouse on the appropriate part of the...
TRANSCRIPT
LatheQuiz
Answer the following questions by left clicking the mouse on the appropriate part of the Wood Lathe.
Copper
1. Where is the tailstock ?
Copper
Tailstock
The tailstock is used to support one end of the work piece when turning between centres.
Copper
2. Where is the toolrest ?
Copper
Toolrest
The Toolrest is used to support the lathe tool when turning
Copper
3. Where is the Forked Centre ?
Copper
Forked Centre
The Forked Centre supports the other end of the work piece.
Copper
4. Where is the Lathe Bed?
Copper
Lathe Bed
The Lathe Bed is made from cast Iron and machined flat to allow the tailstock to slide freely along its length
Copper
5. Where is the Revolving Centre?
Copper
Revolving Centre
The Revolving Centre supports the other end of the work piece.
Copper
6. Where is the Headstock?
Copper
Headstock
The Headstock contains the Drive shaft and Pulleys.
Copper
7. Where is the Isolator?
Copper
Isolator
The Isolator is used to Isolate the Lathes power supply.
8. Which of the above Lathe tools is a Parting tool?
The parting tool can be used to cut narrow slots in your work piece.
The Parting tool
9. Which of the above Lathe tools is a Gouge?
The Gouge utilises a slicing action and can be used for both roughing down and fine finishing
The Gouge
Cross Section
Copper
10. Which of the above Lathe tools is a Skew Chisel?
Copper
The skew chisel can be used to produce a very smooth finish
The Skew Chisel
When using this tool remember only to use the bottom third of the blade
Copper
11. Which of the above Lathe tools is a Scraper?
Copper
The Scraper
Scrapers are among the easiest lathe tools to use however as the name suggests the tool scrapes rather than cuts and can leave a rather rough finish.
Scrapers are available in a wide range of shapes and sizes.
12. Which of the tools shown on the left is a faceplate ?
A Faceplate is used to attach a wood blank to the lathe when making a bowl
The Faceplate
Faceplate
Congratulations you have finished the Wood Lathe Quiz