lifting beam · • designed for project specific rigging options • can be transported in (1)...

Call us today for a free quote

303-761-3183WINSLOW CRANE SERVICE CO.3002 S. Huron Street - Englewood, CO 80110www.winslowcrane.com

CANTILEVERLIFTING BEAM

• Working Load Limit: 25,000 lbs. (tested at 34,000 lbs. with zero deflection)

• Total Weight: 20,000 lbs.

• Max offset from crane hook center: 16'

• Overall length 28'

• Counter-weight adjusted via battery operated, wireless remote control (up to 100 ft.), allowing the operator to maintain beam balance during the lift.

• Designed for project specific rigging options

• Can be transported in (1) legal load

The AMD Cantilever Lifting Beam offers a wireless, self-contained, battery-powered solution that doesn’t require any electrical or hydraulic interface with the crane.

FEATURES

From trailers, gantries, slide systems, to custom engineered products; AMD is proud to provide alternative movement solutions to all ML Crane Group customers. Contact us to learn more about how AMD can solve YOUR alternative movement needs.

CANTILEVERLIFTING BEAM



▪ WORKING LOAD LIMIT 25,000 LBS.▪ TOTAL ASSEMBLY WEIGHT 20,000 LBS. (ALL COUNTER-WEIGHT)

8'-0" 12'-0"

2'-1"

2'-0"

ø1 3/4"SIZED FOR G-2130 17t SHACKLE

ø1 9/16"SIZED FOR G-2130 13.5t SHACKLE

42'-7 1/2"

1 3/4"2"1'-0"

APPROVED BY

DRAWN BY

PLOTTING SCALE

PART NO.

DATE

DATE

REV.

.N.C.EENOZNOISIVER.ON BYDATE

WORKAREA

0

CANTILEVER LIFT BEAM

ALL THREADED AND MACHINED SURFACES ARE TO BE FREE OF PAINT/PRIMER.

M/J LOGO

S/N STAMP REQUIRED. - REFER TO WORK INSTRUCTION QC-010

SURFACE PREPARATION AND COATING:

PRIMER, ZINC RICH: MI-JACK P/N 39900003

FINISH COAT - SEE ADDITIONAL NOTE ON DRAWING.

D14.1-97

5.) THIRD ANGLE PROJECTION

PART IDENTIFICATION REQUIREMENT

REFER TO MI-JACK QUALITY SYSTEMS CLEANING AND COATING PROCEDURE- QC-0014.

IDENTIFY PER QC 4.6.2.b.1.2UNLESS IDENTIFIED ON THISDRAWING BY THE FOLLOWING

1.) ALL DIMENSIONS GIVEN IN INCHES =DO NOT SCALE DRAWING=

PRIMER, UNIVERSAL: MI-JACK P/N 39900004

2.) REMOVE ALL UNNECESSARY BURRS & SHARP EDGES

4.) DIMENSIONAL TOLERANCES UNLESS OTHERWISE SPECIFIED:

3.) UNLESS OTHERWISE SPECIFIED: ALL WELDS USE ROD E7018 L.H. OR EQUIV.WELDS MARKED ARE TO BE ULTRASONIC OR MAGNETIC PARTICLE INSPECTED IN

OTHER WELDS TO BE VISUALLY INSPECTED AS PER A.W.S.(SEE CHART) SECTIONACCORDANCE WITH A.W.S. CODE (SEE CHART) SECTION 8.13&8.16, ANSI, AND ALL

8.6. ALL WELDS AND EDGE PREPARATION SHALL CONFORM TO A.W.S.(SEE CHART)A.W.S. CODE CHART

P.N.SYMBOL:METAL STAMPPAINT MARKER

DECIMAL ........... .XX = ` .03 .XXX = ` .005

GENERAL SPECIFICATIONS:

FRACTIONS ........... ` 1/16

NONE

ETCH

ANGLES ............ `2~

6.)

D14.1-85

LABELTAG

CANTILEVER LIFTING BEAM



lifting beam · • designed for project specific rigging options • can be transported in (1)...

Documents