Wing Clips

Lock Cam

Figure 1

Figure 4

Figure 3

Wing Clip Notches

Figure 2

Note: Do not place your �ngers behind or slide your �ngers along the sheet metal edges.

To replace the lock in your �le cabinet you must �rst remove the old lock.

To remove the old lock:

1. Open the drawer and locate the Wing Clips which hold the lock in place. (Figure 1)

2. With a �athead screwdriver push the Wing Clips toward the lock body and push the lock body forward until the Wing Clip on that side is slightly protruding out of the drawer front.

3. Again using the �athead screwdriver push the Wing Clip on the other side toward the lock body and push forward until the lock can be removed from the drawer.

To install the new lock:

1. Make sure that the cam is in the unlocked position by turning the key counterclockwise as far as it will go.

2. Feed the lock cam through the hole in the dawer front so the Lock Cam is pointing toward the center of the drawer (Figure 2) and align the Wing Clips with the notches in the drawer front (Figure 3).

3. Push the lock into the drawer front until the Wing Clips pass through the drawer front and snap into place behind the drawer front (Figure 4).

Lock Replacement Instructions

SHEET 1 OF 1

3636 Westown Parkway, West Des Moines, Iowa www.hirshindustries.com 1-800-383-7414

HANGING FOLDER SUPPORT INSTALLATIONThis filing cabinet can be used with hanging file folders by simply

installing two folder supports per drawer as follows:

Step 1: Slide the drawer half way out of the cabinet to allow access to the drawer sides. Identify the two small square tabs on each side of the drawer near the front. (See Figure 1).

Step 2: From the outside of the drawer, push the tabs inward until they are at a 90 degree angle to the drawer side. (See Figure 2).

Step 3: Install one folder support into each drawer side through the top holes and then through the square tab. (See Figure 2). Note: After the installation of the support, the bend in the support should remain above the top of the drawer and should point toward the center of the drawer.

Step 4: Place several hanging folders in the drawer to ensure proper support positioning.

Step 5: Repeat steps 1-4 for each drawer.

Square Tab

Step 1

Figure 1

Step 2

Step 3

Figure 2

Bend

West Des Moines, Iowa www.hirshindustries.com 1-800-383-7414 No. 18900 09/2012

BEFORE YOU BEGINOpen, identify, and count all parts prior to assembly.

(2) Front CasterA.(2) Rear CasterB.(8) ScrewC.(2) Caster BracketD. B.A. C. D.

Caster Kit Assembly Instructions

STEP 1 - Attach Front Casters:Align screw holes in front caster mounting platewith the screw holes in the bottom of cabinet.

Connect the Front Casters (A) with Screws (C)using a phillips screwdriver. Fully tighten all screws.

STEP 2 - Attach Rear Casters:Position v-bends of Caster Bracket (D) up under cabinet rims.

Align screw holes in rear caster mounting plate with screwholes in Caster Bracket (D) ensuring the mounting platecovers the bottom corner of the cabinet. (Figure 4)

Connect the Rear Caster (B) and the Caster Bracket (D) withScrews (C) using a phillips screwdriver. Fully tighten allscrews. A

C

2x

mounting plate B

C

D

2x

mounting plate

rim

v-bend

Screw (C)

FIGURE 3: Complete assembly. FIGURE 4: Close-up of rear caster assembly.

www.hirshindustries.com 800.383.741411/06/2013

rear casters

front casters