macbook pro 13' unibody early 2011 ram installation · pdf filemacbook pro 13"...
TRANSCRIPT
MacBook Pro 13" Unibody Early 2011 RAMInstallation
Upgrade the RAM in your Early 2011 MacBook Pro 13" Unibody.
Written By: Dozuki System
MacBook Pro 13" Unibody Early 2011 RAM Installation
© 2017 guides.crucial.com Page 1 of 6
INTRODUCTION
Upgrade your RAM for a noticeable increase in speed.
TOOLS:Phillips #00 Screwdriver (1)
Spudger (1)
PARTS:RAM Upgrade Kit (1)
MacBook Pro 13" Unibody Early 2011 RAM Installation
© 2017 guides.crucial.com Page 2 of 6
Step 1 — Lower Case
Remove the following ten screws:
Three 14.4 mm Phillips screws
Three 3.5 mm Phillips screws
Four 3.5 mm shouldered Phillipsscrews
Step 2
Use your fingers to pry the lower case away from the body of the MacBook near the vent.
Remove the lower case.
MacBook Pro 13" Unibody Early 2011 RAM Installation
© 2017 guides.crucial.com Page 3 of 6
Step 3 — Battery
Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board.
It is useful to pry upward on both short sides of the connector to "walk" it out of its socket.
Step 4
Bend the battery cable slightly awayfrom its socket on the logic board soit does not accidentally connectitself while you work.
MacBook Pro 13" Unibody Early 2011 RAM Installation
© 2017 guides.crucial.com Page 4 of 6
To reassemble your device, follow these instructions in reverse order.
Step 5 — RAM Installation
Pull the two RAM retaining arms away from the center of the RAM module.
The RAM module should "pop" up slightly from its socket.
Step 6
Pull the RAM module out of itssocket.
Repeat this process to remove thesecond RAM module.
MacBook Pro 13" Unibody Early 2011 RAM Installation
© 2017 guides.crucial.com Page 5 of 6
This document was last generated on 2017-06-16 02:37:35 PM.
MacBook Pro 13" Unibody Early 2011 RAM Installation
© 2017 guides.crucial.com Page 6 of 6