Justin Hunt’s Manufacturing Portfolio

•  2.5-5 axis CNC mill programming.• Fixture and tooling design.•  CNC Lathe Programming.• Examples are produced with CAMworks and Mastercam.

Endorsed Cutting Technology:• Sandvik• Harvey Tool• Hanita• Data Flute• Mitsubishi• Greenleaf

4 axis VMC programming with a Haas indexer•  Reproduction of a legacy aircraft part made from 17-4 S.S.• Component has been reversed engineered from legacy print data.

Close up of a 45 degree raster pattern tool path machined with a Sandvik ½ inch index ball mill at 0 degrees.

2 axis Lathe tool paths(304 S.S. w/ 32 finish)

• O.D. Roughing• O.D. Finishing• O.D. Groove • O.D. Threading (18 TPI)• Spot drill & Drilling (1/2 jobber)• I.D. Roughing• I.D. Finishing• I.D. Groove• O.D. Cut off operation

3 axis VMC aerospace part using a Chick One-Lock® vice and a Prototrack bed mill.

Tool paths are generated using CAMWorks. Shown is 3 axis flowline And a 3D roughing pocket.

Center: A 3 axis fillet tool path machined with a ¼ ball mill.This tool must stop at the wall perpendicular to the fillet feature in order to avoid an unwanted collision

.

3 axis Semi-finish +.015 Flow line tool path using a 1/16 ball mill

Mastercam 2D Drilling on a side operation

Mastercam 3D roughing

Mastercam 3D flow line finish.This verify can be watch on myYoutube Channel (BPDevices)

Top left: EDM graphite electrode Top right: A 3D Constant step over roughing tool path. Bottom Right: 3D constant step over finish path with a .015 ball mill

4 X HMC manufacturing with Kurt Cluster Tower® on a two operation part.

Operation 2 soft jaws keep the second operation part in position.

Assortment of VMC manufacturing plans. 

Assortment of HMC manufacturing plans.