mclicker application manual

8/10/2019 MClicker Application Manual

1/21

!"#$%&'( *++#$%,-$./ 0,/1,# 2

mClicker User Manual

Table of Contents34-,5#$46$/7 , ".//'%-$./ 8

*$( 0.14' 0.9' :

;.1%6+,9 0.9' I B


2/21

!"#$%&'( *++#$%,-$./ 0,/1,# 8

Establishing a Connection

1. Install mClicker for iPhone from the Apple App Storehttp://itunes.apple.com/us/app/mclicker/id435061828?mt=8&ls=1

2.

Download mClicker server from

http://mclicker.com/Content/IMouseService.Setup.msi

3. Install mClicker server and run it. Choose network adapter and the IP address ofthe PC where the server is running. This usually is Local Area Connection.

4. Select a port the default port is 10552 - please note that if you have fire wallrunning on your PC you should create an exception for that port and open it.

5. Press START SERVICE button at the bottom left corner of SERVER SETTINGSscreen.


3/21

!"#$%&'( *++#$%,-$./ 0,/1,# J

6.

Run mClicker on your iPhone device and it will automatically connect to the server7. Skip the next section if you are not interested in manual setup/troubleshooting


4/21

!"#$%&'( *++#$%,-$./ 0,/1,# K

8.

Choose Unicast and enter in address box the IP address of the server the onethat was selected on step 3 of this manual. Enter the port number the sameone which was selected on step 4 of this manual. Switch ON network at thetop of the screen and go to Mouse screen the last tab at the bottom right ofyour iPhone device screen.


5/21

!"#$%&'( *++#$%,-$./ 0,/1,# :

Air Mouse Mode

In this mode you can control the mouse pointer of your PC by rotating your iPhone leftand right in order to move the pointer respectively left and right and by tilting the phonedevice up and down to move it up and down. You can also adjust the sensitivity of thepointer on the server app. Go to mClicker server and choose MOTION SETTINGS tab.Use the three sliders to control the sensitivity of the mouse pointer (left is slow, rightfast). In case you need to reset the settings press USE DEFAULT SETTINGS button.


6/21

!"#$%&'( *++#$%,-$./ 0,/1,#

mclicker application manual

Documents