mig-29 fulcrum 9-13 interior s.a. 49 657 - eduard · mig-29 fulcrum 9-13 interior s.a. 49 657 1/48...
TRANSCRIPT
1/3
MiG-29 Fulcrum 9-13 interior S.A.
49 657
49 6571/48 scale detail set for Great Wall Hobby kit • sada detailů pro model 1/48 Great Wall Hobby
ORIGINAL KIT PARTSPŮVODNÍ DÍLY STAVEBNICE
PHOTO-ETCHED PARTSLEPTANÉ DÍLY
PARTS TO BE REMOVEDDÍLY K ODSTRANĚNÍ
FILLTMELIT
eduard
REMOVEODSTRANIT
OPTIONVOLBA?REPLACENAHRADIT
BENDOHNOUT
GRINDOBROUSIT
SYMETRICAL ASSEMBLYSYMETRICKÁ MONTÁŽ
DRILL HOLEVRTAT OTVOR
APPLY EXPRESS MASK AND PAINT BEFORE GLUINGPOUŽÍT EXPRESS MASK NABARVIT PRED SLEPENÍM
1 COLORED ETCHED PARTSLEPTANÉ BAREVNÉ DÍLY
28
28
18
3
23
4
22 5526
14
15
13
1253
52
49
45
44
17
25
3536
16
21
10
26 48
41
42
C43, C44, C72
=
3334
27
2
1
32
20
C47
6
19
9 29
C46
C68
C37
FILM
© EDUARD M.A. 2013 www.eduard.com Made in Czech Republic
eduardFor further detail sets look for 48 787 MiG-29 Fulcrum 9-13 exterior(not included in this set)
2/3 49 657
62
24
31 30
=
C66, C73
43
56
59
57
58
A1
47
61
60
C36
C39
PE14
5450
film
A1
PE8
39
38 37
51
40
C65, E2
8
7
11
=
C45
C38
C71
5
46
2 pcs.
E1
(not included in this set)
eduardFor further detail sets look for 48 786 MiG-29 Fulcrum 9-13 F.O.D. and ladder
2. Do not inadvertently place etched componets on an unwanted surface. Attempts to remove will result in damage to your part.
2. Nepokládejte samolepící díly na volné plochy. Pokud je omylem přilepíte, při pokusu o odlepení dojde k poškození dílu.
3. Do not touch the adhesive areas of the etched components.
3. Nesahejte na části dílů, na kterých je naneseno lepidlo.1. Separate the etched components from their frames on the protective paper. Removal from the paper is done only after separation of the parts from the frames.
1.Samolepící díly oddělujte od rámečku na podkladovém papíře. Po oddělení je sejměte z krycího papíru.
4. Hold the parts by the edges, or at areas free of adhesive.
4. Samolepící díly berte za hrany nebo za části, na kterých není nanesené lepidlo.
5. Lightly place the component in the desired location and position. Adjust as required. The component will be permanently affixed when pressed onto its intended location, its location can be adjusted.
5. Díl lehce položte do pozice, ve které má být nalepen. Upravte přesnou pozici a přimáčkněte. Díl dokonale přilne až po přimáčknutí, před přimáčknutím lze dílem opatrně manipulovat.
PARTS WITH GLUE DÍLY OPATŘENÉ LEPIDLEM
3/3 49 657