mitsubishi magna / verada sedanmantank.com.au/.../03/26514.9te-twmitsubishimagna.pdf · mitsubishi...
TRANSCRIPT
C:My documents\salesofficeandrew\Magna TE -TW Sedan.
Revision 1 – 24/08/10
This is an Uncontrolled document.
26514.9
L.P. GAS CYLINDER
INSTALLATION INSTRUCTIONS
MITSUBISHI MAGNA / VERADA SEDAN
This cylinder is design to fit: Mitsubishi Magna sedans - April 1996 to September 2005
(TE, TF, TH, TJ, TL*, TW*)
*Note! This cylinder will not fit All Wheel Drive (AWD) models.
This Automotive LP Gas cylinder must be installed in the vehicle in strict accordance with the latest
requirements of AS/NZS1425. Any modifications to the cylinder will render the warranty null and void.
General Cylinder Specifications:
DIAMETER : 375mm LENGTH : 860mm
WATER CAPACITY: 85L L.P GAS CAPACITY : 68L
VALVE ORIENTATION : 30 degrees
Installation:
This cylinder is designed to be mounted Remove the floor mat, jack and spare
in the luggage compartment, below the wheel from the boot.
parcel shelf.
C:My documents\salesofficeandrew\Magna TE -TW Sedan.
Revision 1 – 24/08/10
This is an Uncontrolled document.
Place the cylinder into position and mark the Drill the holes marked using a 13mm dia
mounting hole locations with a permanent marker. drill bit. The front holes will need to be drilled
The front holes are to be in the centre of the through the centre of the channel section shown channel section that passes under the floor. above. Using a hole saw, drill the top only of the
front holes 22mm dia to accommodate the
crush tubes.
Refit the carpet cutting 2 holes for the rear Trim the carpet around the brackets so the
brackets to run through. brackets are bolted directly to the floorpan
and bolt down the rear brackets using the crush
tube in the channel section.
Bolt down the rear brackets to the floorpan. Trim the spare wheel cover board to fit around
the brackets.