Installation Instructions

Model PKM600 PowerKEY CableCARD Module

What is the PowerKEY CableCARD Module?The PowerKEY® CableCARD™ Module provides you with greater choice in your cable TV entertainment and communications. Note: For installation in compatible TVs and home terminals. Not intended for use in a personal computer or a laptop, unless the device is specifi cally designated for such use.

Important: Do not remove the PowerKEY CableCARD Module after you install it. Removing the module may cause a temporary loss of your cable services.

Before You BeginBefore you install the PowerKEY CableCARD Module, record the two lines of alphanumeric characters that appear on the bottom left corner of the module, below the bar codes as shown in the example diagram. You may need to give this information to your cable service provider after you install the module.

Line 1: _____________________________

Line 2: _____________________________

Installing the PowerKEY CableCARD ModulePerform the following steps to install the PowerKEY CableCARD Module.

1. Refer to the TV or home terminal documentation to locate the appropriate slot in which to insert the module.

Note: This diagram shows a Scientifi c-Atlanta Explorer®

Digital Home Communications Terminal (DHCT). If you are installing the PowerKEY CableCARD Module in a diff erent device, refer to the instructions that came with that device for specifi c information.

PKAAAABCD

001AA22B12B

1

2. Follow the instructions that came with the TV or home terminal to insert the module into the slot until it is fi rmly seated.

CAUTION: Do not try to force the module into the slot. Doing so could damage the module, the home terminal, or the TV.

3. After you insert the module, the module and host device IDs appear automatically on your TV screen, along with instructions and a telephone number to call.

Note: If you do not see this information on the TV screen, the module may not be inserted properly. Try removing the module, turning it over and re-inserting it. If the problem persists, contact your cable service provider.

4. Record these IDs and the telephone number in the spaces below, and call your cable service provider as instructed.

CableCARD ID: ________________________________________________

Host ID: ____________________________________________________

Telephone Number: ____________________________________________

Note: You may also need to give your cable service provider the alphanumeric information you recorded earlier in the Before You Begin section.

5. Refer to the documentation that came with your TV or home terminal for instructions on operating the TV or home terminal with the module.

If You Have Problems• If you installed the PowerKEY CableCARD Module in a home terminal and

received a code on its front panel display, refer to the documentation that came with the home terminal for instructions.

• If you installed the PowerKEY CableCARD Module in a TV and received an error message on the TV screen, refer to the documentation that came with the TV for instructions.

• Contact your cable service provider if you continue to have problems.

2

United States FCC ComplianceThis equipment has been tested and found to comply with the applicable limits of Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or TV reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Increase the separation between the equipment and receiver• Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected• Consult your cable company or an experienced radio/TV technician for helpAny changes or modifi cations not expressly approved by Scientifi c-Atlanta could void the user’s authority to operate the equipment.Important: The information shown in the FCC Declaration of Conformity paragraph below is a

requirement of the FCC and is intended to supply you with information regarding the FCC approval

of this device. The phone numbers listed are for FCC-related questions only and not intended for

questions regarding the connection or operation for this device. Please contact your cable service

provider for any questions you may have regarding the operation or installation of this device.

Declaration of ConformityThis device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: 1) the device may not cause harmful interference, and 2) the device must accept any interference received, including interference that may cause undesired operation.

PowerKEY® CableCARD ModuleModel PKM600

Manufactured by: Scientifi c-Atlanta, Inc.;5030 Sugarloaf Parkway;

Atlanta, Georgia 30042; USA

Telephone: 770 236-1077

Canada EMI RegulationThis Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations.Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.

Cisco Systems, Inc. 678 277-11205030 Sugarloaf Parkway, Box 465447 800 722-2009Lawrenceville, GA 30042 www.cisco.com

Cisco and the Cisco logo are trademarks of Cisco Systems, Inc. and/or its affi liates in the U.S. and other countries. A listing of Cisco’s trademarks can be found at www.cisco.com/go/trademarks. CableCARD is a trademark of Cable Television Laboratories, Inc. Other third party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1009R)

©2000, 2003, 2011 Cisco and/or its affi liates. All rights reserved.

January 2011 Printed in United States of America Part Number 736104 Rev D